Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES

DIAGNOSTIC TESTS AND ERROR CODES				M2488 PRODUCT GUIDE
	Table F-23. Routine 82 - Magnetic Tape Unit Diagnostic Error Codes
ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x82	*	MTU diagnostics routine	0xE0	A DVL card was not detected. This routine
				requires that the DTC card be properly con-
				nected to a DVL card.
0x82	0x01	MTU diagnostic load execute	-	(No error codes specific to this test)
		table
0x82	0x02	MTU diagnostic send execute	0x01	The MTU diagnostic parameters were not
		table		successfully downloaded through the Servo
				Shared RAM Interface.
0x82	0x03	MTU diagnostic run	0x01	Servo Interface indicated that a servo com-
				mand was not accepted
			0x02	Servo Interface indicated that an error
				occurred while processing the current Servo
				Command. Sense information was built.
			0x03	The current servo command failed to com-
				plete in the allocated time.
			0x04	An error occurred during execution of the cur-
				rent servo command. Sense information was
				built.
			0x05	No valid test groups were found.
0x82	0x04	MTU diagnostic retrieve results	0x01	An error occurred attempting to retrieve the
		table		MTU diagnostic results through the Servo
				Shared RAM Interface.

Table F-24. Routine 83 - Operator Control Panel Diagnostic Error Codes

ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x83	*	All Operator Control Panel tests	0xE0	Operator Control Panel interface to the DTC
				card not detected.
0x83	0x01	Operator Control Panel keys test	0x01	RESET switch press not detected in allotted
				time.
			0x02	RESET switch release not detected in allotted
				time.
			0x03	UNLOAD switch press not detected in allot-
				ted time.
			0x04	UNLOAD switch release not detected in allot-
				ted time.
			0x05	START switch press not detected in allotted
				time.

F-76 CG00000-011503 REV. A April 1997