Fujitsu Appendix D Fault Symptom Codes, M2488 Product Guide Fault Symptom Codes, 3CAE, 3CAF

M2488 PRODUCT GUIDE FAULT SYMPTOM CODES

APPENDIX D

FAULT SYMPTOM CODES

The Fault Symptom Codes (FSCs) are described in Table D-1 and Table D-2. Refer to Table 8-14 on page 8-15 for the FSCs listed in Table D-1. The FSCs listed in Table D-2 are the FSCs returned in bytes 22-27 of the Format 01h Sense Information described in paragraph 8-3.2 on page 8-9.

	Table D-1. Error Recovery
F.S.C #	DESCRIPTION
3C80	Diagnostic Test Failure
3CA0	SCSI DMA XFER poll timeout
3CA1	SPC DMA data send (e.g. Read) parity error reported to SCSI manager
3CA2	SPC DMA data receive (e.g. Write) parity error reported to SCSI manager
3CA3	SPC manager reported to SCSI manager that an initiator detected error message was received on DMA
	transfer
3CA4	SPC manager reported to SCSI manager that a data xfer error occurred during DMA data transfer
3CA5	SPC manager reported to SCSI manager that a REQ/ACK timeout occurred during DMA data transfer
3CA6	SPC manager reported to SCSI manager that an SPC command timed-out during DMA data transfer
3CAE	SPC manager reported to SCSI manager that an unknown SPC error occurred during DMA data transfer
3CAF	SCSI manager encountered an unknown error occurred during DMA data transfer
3CB0	Write buffer copy to flash failed
3CB1	NVRAM read failure
3CB2	NVRAM write failure
3CB3	NVRAM allocate failure
3CB4	RM and SPC residual mismatch on read long
3CC0	Sense built after retries done for IDE message
3CC1	Initiator’s message reject message didn’t make sense
3CC2	Initiator’s message didn’t make sense
3CC3	Overlapped commands were attempted
3CC4	REQ/ACK timed-out in MSGIN, retries failed
3CC5	Parity error in MSGOUT, retries failed
3CC6	REQ/ACK timed-out in MSGOUT, retries failed
3CC7	REQ/ACK timed-out in CMD, retries failed
3CC8	Parity error in CMD phase, retries failed
3CC9	Parity error in DATA phase, retries failed

April 1997 CG00000-011503 REV. A D-1