Fujitsu manual Erpa Codes M2488 Product Guide

ERPA CODES		M2488 PRODUCT GUIDE
		Table C-1. ERPA Codes (Continued)
ERPA	DESCRIPTION	ERROR
CODE
35	Drive Equipment	One of the following has occurred:
	Check	1. The control unit cannot recover from a drive-detected error.
		2. A check code message is displayed on the drive message display.
		3. The automatic cartridge loader does not respond across the interconnection to the
		tape drive.
		4. A failure occurred during an index/load or unload cycle. The tape cartridge is not
		manually retrievable by the operator.
36	End-of-Data	An End-of-Data (EOD) mark was detected on the tape during a read operation.
	Detected on Read
37	Tape Length Error	The tape length in the cartridge is too short. The error could occur when the leader
		block is replaced (the length of tape ahead of the BOT has been trimmed).
38	Physical End of Tape	A read or write operation was in process when the physical end-of-tape was reached.
		The drive does not pull the tape out of the cartridge.
39	Backward at BOT	While the tape was moving backwards, the beginning of tape was reached.
3B	Volume Removed by	The Rewind Unload switch on the drive has been activated and the cartridge is
	Operator	unloaded.
41	Block ID Sequence	The control unit detected an incorrect Block ID sequence.
	Error
43	Intervention Required	A CDB was issued to a drive that is not ready.
44	Locate Block Unsuc-	The control unit cannot find the block preceding the desired block.
	cessful
47	Control Unit Error	The SCSI error processing microcode received an unrecognized ERPA code. Process-
		ing continues.
49	Bus Out Parity	The bus out parity error was detected on the command or parameter transfer.
4A	Control Unit ERP	The control unit could not recover from a data handling failure.
	Failed
4C	Recovered Hardware	The control unit recovered from a hardware error.
	Error
5B	Tape Extension Error	An attempt was made to write 36-Track format data on 18-Track formatted medium.
5C	Medium Changer	A Medium Changer command was given to a device that does not have the Medium
	Command	Changer feature.
5D	Tape Length Error	The tape length in the cartridge is too long.
5E	Compaction Algo-	An attempt was made to read an unsupported data compaction algorithm.
	rithm Incompatible
6F	No Cartridge	No cartridge at selected location; or selected location not within the magazine size; or
		no magazine was present when an attempt was made to load a cartridge from the mag-
		azine.
77	Reel Diameter	Reel Diameter Greater than ECCST
	Greater than ECCST

C-2 CG00000-011503 REV. A April 1997