Fujitsu M2488 manual +/- ces

MAINTENANCE AND SERVICING		M2488 PRODUCT GUIDE
COMMAND	DESCRIPTION	VARIABLES/ARGUMENTS
List	List current tests in test list or	List arguments:
List [n] [e]	list test registry. Entering “List”	n -Node number in current test list to list, or being listing from. If n
	will display all of the tests in the	is not specified or is an asterisk “*”, then the entire test list will be
List [Regis-
	current test list. Entering “List	displayed. If only n is specified, then only the test at that node
try] [r] [t]
	Registry” will display the regis-	number will be displayed.
	try of all of the tests available	e -End node number in current list to stop listing at. If an asterisk
	for use in the current diagnostic	“*” is entered, all tests beginning with n will be displayed.
	mode. The list command may be
	aborted by pressing	List Registry arguments:
	<RETURN> before all tests are	r -Routine number in test registry to be displayed. If an asterisk
	displayed.	“*” is entered, then all routines in the current diagnostic mode will
		be displayed.
		t -Test number of routine r in test registry to be displayed. If an
		asterisk “*” is entered, all tests for routine r will be displayed.
Options o:	Set test options for all tests in	o -Options byte for this list of tests. The options byte is arranged
[+/-] [c:e:s]	the current test list.	into bit fields as illustrated in the Table 8-18.
Quit	Quit Off-Line diagnostics
	mode. (Entering this command
	will cause a return to the previ-
	ous operating mode.)
Run [macro]	Run tests in current test list. This	# - The number of times to execute the entire list of tests. By
[#]	command is used to begin test	default, the list will only execute one time. To loop forever, enter
	execution. Tests are executed in	0.
	sequential order beginning with	macro - One of several predetermined test lists. Macro names are
	the first node. The test options	listed when entering “help macros” at the command line prompt.
	byte for each test may modify
	execution behavior. At any point
	during test list execution, the
	operator may abort execution of
	the test list at the conclusion of
	the current test.
Node n l	Set loop count for test at node #	n - Node number to change loop count for. This number must be
	n in the current test list	in the range of node numbers in the current list.
		l - Loop count, the number of times to repeat the test at the speci-
		fied mode.

8-22 CG00000-011503 REV. A April 1997