Fujitsu M2488 manual Allowed Source and Destination Elements, Read Element Status Sense Keys

M2488 PRODUCT GUIDE MEDIA CHANGER COMMANDS

6-2.5.3 Source and Destination Elements

Table 6-33 shows when an element is allowed to be source or destination for a MOVE MEDIUM or EXCHANGE MEDIUM command based upon the element’s Full and Access status bits.

Table 6-33. Allowed Source and Destination Elements

				ALLOWED AS	ALLOWED AS
ELEMENT	ELEMENT	ALLOWED	ALLOWED AS	FIRST	SECOND
			DESTINATION	DESTINATION	DESTINATION
ACCESS	FULL	AS SOURCE
			ELEMENT FOR	ELEMENT FOR	ELEMENT FOR
STATUS	STATUS	ELEMENT
			MOVE MEDIUM	EXCHANGE	EXCHANGE
				MEDIUM	MEDIUM
0	0	N	N	N	N
0	1	N	N	N	N
1	0	N	Y	N	Ya
1	1	Y	N	Y	Yb

a.Only if the Second destination element is different from the Source element.

b.Only if the Second destination element is the same as the Source element.

6-2.5.4 READ ELEMENT STATUS Sense Keys

One of the following sense keys may be returned if a CHECK CONDITION was indicated:

SENSE KEY	CONDITION		DESCRIPTION
5h	ILLEGAL REQUEST	1.Reserved bit was found set in the CDB of the READ ELE-
		MENT STATUS command.
		2.	Illegal value used in Element type code field of the CDB.
		3.	The Flag bit was set but the Link bit was not set.
6h	UNIT ATTENTION	Indicates the READ ELEMENT STATUS command was not per-
		formed due to one of the following:
		1. A NOT READY TO READY transition has occurred.
		2.	The target has been reset.
		3.	The Medium-changer Mode parameters have been changed by
			another initiator.
		4.	The version of the microcode has been changed (microcode
			downloaded).
		5.	A cartridge was loaded with a tape length that is too long or too
			short.
Bh	ABORTED COMMAND	READ ELEMENT STATUS command was aborted. The READ
		ELEMENT STATUS command can be reissued.

March 1997 CG00000-011503 REV. A 6-29