Fujitsu manual Tape Unit PARAMETERSM2488 Product Guide

TAPE UNIT PARAMETERSM2488 PRODUCT GUIDE

Table 5-16. Density Codes Reported by Mode Sense Command with DENSITY_CODE_28H Configured

WHEN THE FOLLOWING IS TRUE	MODE SENSE WILL REPORT
After a Power Up sequence, when the unit is in the READY state, and the	Density Code relating to the tape format
tape format has been determined by the unit.	as determined by the unit.
When the unit is in the READY state, and a successful read has been done	Density Code 09h
from an 18T tape.
When the unit is in the READY state, and a successful read has been done	Density Code 28h
from an 36T tape.
After a successful read or unsuccessful write at BOP, if a previous Mode	Density Code as set by the Mode Select
Select command had been issued to set the Density Code.	command.
After a successful read or unsuccessful write at BOP, if the unit has not iden-	Density Code 28h
tified the tape format.
After a successful read or unsuccessful write at BOP, if the unit has identified	Density Code relating to the tape format
the tape format.	as determined by the unit.

*An Unload is considered to be a ready-to-not-ready transition which can result from the Unload command, the Move Medium command, or by pressing Reset on the op-panel.

5-16 CG00000-011503 REV. A April 1997