Fujitsu M2488 manual Move Medium Sense Keys, Sense KEY Condition Description

MEDIA CHANGER COMMANDS M2488 PRODUCT GUIDE

6-2.4.3 MOVE MEDIUM Sense Keys

One of the following sense keys may be returned if a CHECK CONDITION was indicated:

SENSE KEY	CONDITION		DESCRIPTION
2h	NOT READY	Logical Unit is not ready (magazine not set or if set, then START button
		not pressed or magazine not loaded via host command).
3h	MEDIUM ERROR	1. Medium exchange failed due to synchronization failure.
		2.	An attempt was made to write 36-track data on 18-track formatted
			medium.
4h	HARDWARE ERROR	Medium move failed due to hardware failure.
5h	ILLEGAL REQUEST	1. If this command is received and the XCL (ACL or FACL) is not
			attached, the target shall return CHECK CONDITION status and set
			the sense key to ILLEGAL REQUEST.
		2.	If this command is received and the XCL (ACL or FACL) is not in
			SYSTEM MODE, the target shall return CHECK CONDITION sta-
			tus and set the sense key to ILLEGAL REQUEST.
		3.	If this command is received and the source element is empty or the
			destination element (if different from the source element) is full, the
			target shall return CHECK CONDITION status and set the sense key
			to ILLEGAL REQUEST.
		4.	The transport element address specifies the medium transport element
			that is to be used in executing this command. The default medium
			transport element address of zero may be used if this functionality is
			supported by the medium changer device. If the address specified has
			not been assigned or has been assigned to an element other than a
			medium transport element, the target shall return CHECK CONDI-
			TION status and the set the sense key to ILLEGAL REQUEST.
		5.	The source address and the destination address may represent a stor-
			age element, an import export element, a data transfer element, or a
			medium transport element. If the address specified has not been
			assigned to a specific element of the medium changer, the target shall
			return CHECK CONDITION status and set the sense key to ILLE-
			GAL REQUEST.
		6.	Reserved bit was found set in the CDB.
		7.	The Flag bit was set but the Link bit was not set.
6h	UNIT ATTENTION	Indicates the MOVE MEDIUM command was not performed due to one
		of the following:
		1. A NOT READY TO READY transition has occurred.
		2.	The target has been reset.
		3.	The Mode parameters have been changed by another initiator.
		4.	The version of the microcode has been changed (microcode down-
			loaded).
		5.	A cartridge was loaded with a tape length that is too long or too short.
Bh	ABORTED COMMAND	MOVE MEDIUM command was aborted.
Dh	VOLUME OVERFLOW	Write of buffered data prior to the MOVE MEDIUM operation failed
		because physical End-of-Tape has been reached.

6-18 CG00000-011503 REV. A March 1997