Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES

DIAGNOSTIC TESTS AND ERROR CODES				M2488 PRODUCT GUIDE
	Table F-5. Routine 3 - CP Bus Parity Diagnostic Error Codes (Continued)
ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x03	0x03	CP Bus parity - SPC	0x04	An unexpected Check 1 condition was pend-
				ing after an attempt to clear it was made
			0x05	An expected CP bus parity was not detected
				after attempting to read an SPC register with
				SPC parity inverted
			0x06	An unexpected Check 1 condition was pend-
				ing after an attempt to clear it was made
			0x07	An unexpected Check 1 condition was
				detected
			0x10	Initialization of the SPC chip failed
			0x20	SPC interrupt request was not generated dur-
				ing SPC Diagnostic initialization
			0x21	An SPC interrupt was not detected in the
				Interrupt Request Controller (IRC) during
				SPC Diagnostic initialization
			0x22	The SPC interrupt was inadvertently cleared
				when the Interrupt Request Controller was
				cleared
			0x23	The SPC interrupt/step code did not report
				command complete as expected
			0x24	The SPC interrupt request could not be
				cleared
			0x30	An SPC interrupt request was not generated
				by the SPC during diagnostic test
			0x31	An SPC interrupt was not detected in the
				Interrupt Request Controller (IRC) during
				SPC Diagnostic initialization
			0x32	The SPC interrupt was inadvertently cleared
				when the Interrupt Request Controller was
				cleared
			0x33	The SPC interrupt/step code did not report a
				Register Parity error as expected
			0x34	The SPC interrupt request could not be
				cleared
			0x40	An SPC interrupt request was not generated
				by the SPC during diagnostic test
			0x41	An expected SPC interrupt was not detected
				in the Interrupt Request Controller (IRC)
			0x42	The SPC interrupt was inadvertently cleared
				when the Interrupt Request Controller was
				cleared

F-12 CG00000-011503 REV. A April 1997