Fujitsu M2488 manual VPD Page Format Field Description

MEDIA CHANGER COMMANDS M2488 PRODUCT GUIDE

Table 6-52. VPD Page Format Field Description

BYTE	BIT	VALUE	DESCRIPTION
0	0-7		The meaning of the Peripheral Qualifier and Peripheral Device Type fields depend
			on whether the VPD page is being sent to the initiator as INQUIRY data or is being
			received from the initiator as CHANGE DEFINITION data. When being sent as
			INQUIRY data, these fields are the same as those defined in the INQUIRY com-
			mand description. When being received as CHANGE DEFINITION data, these
			fields are ignored.
1	0-7		The Page Code field identifies the format and parameters defined for that VPD
			page.
3	0-7		The Page Length field indicates the length in bytes of the VPD parameters that fol-
			low. For VPD pages that are permitted to be sent from an initiator via the
			CHANGE DEFINITION command, if the initiator does not set this value to the
			value that is returned for that page by the INQUIRY command, the target terminates
			the CHANGE DEFINITION command with CHECK CONDITION status. The
			sense key is set to ILLEGAL REQUEST and the additional sense code is set to
			INVALID FIELD IN PARAMETER LIST. For VPD pages requested by an initia-
			tor via the INQUIRY command, if the allocation length in the INQUIRY CDB is
			too small to transfer all bytes in the VPD page, the page length is not adjusted to
			reflect the truncation.
4-N			The VPD parameters for each page are described in the following sections.

6-4.2 Supported VPD Pages - Page 00h

VPD page 00h returns a list of the vital product data pages supported by this target. The format for VPD Page 00h is:

Table 6-53. INQUIRY Data Format VPD Page 00h - Supported VPD Pages

						BITS
BYTES	7		6	5		4	3	2	1	0
0		Peripheral Qualifier					Peripheral Device Type =08h
1						Page Code = 00h
2						Reserved
3					Page Length = 04h
SUPPORTED PAGE LIST
4						00h
5						81h
6						82h
7						C2h

6-42 CG00000-011503 REV. A March 1997