Fujitsu M2488 manual Sddp

M2488 PRODUCT GUIDE				DIAGNOSTIC TESTS AND ERROR CODES
Table F-15. Routine 13 - EDRC Error Detection Diagnostic Error Codes (Continued)
ROUTINE	TEST	TITLE	ERROR		DESCRIPTION
			CODE
0x13	0x01	Write Hi_data parity error check	0xA3		SPC interrupt/step code did not report Diag-
					nostic Self-Test passed
			0xA4		The SPC interrupt request could not be
					cleared
			0x01		Bad SPC write initialization status.
			0x02		Incorrect SPC SCSI control signal status wait-
					ing for REQ signal assertion.
			0x03		Incorrect SPC SCSI control signal status wait-
					ing for REQ signal deassertion.
			0x04		Error reported by record manager attempting
					to request buffer for write clear SG-bypass.
			0x05		Data transfer length error reported by SPC.
			0x06		Expected data parity error on high byte of the
					DMA bus from SPC failed to be reported by
					SDDP.
			0xB0		SPC did not generate an interrupt request
			0xB1		SPC interrupt was not detected at the Interrupt
					Request Controller
			0xB2		The SPC interrupt was cleared while clearing
					the Interrupt Request Controller.
			0xB3		SPC interrupt/step code did not report Diag-
					nostic Self-Test passed
			0xB4		The SPC interrupt request could not be
					cleared
0x13	0x02	Read Hi_data parity error check	0x01		Failed to receive data end-of-transfer signal in
					SDDP hdxs register.
			0x02		Incorrect SPC SCSI control signal status wait-
					ing for REQ signal assertion.
			0x03		Incorrect SPC SCSI control signal status wait-
					ing for REQ signal deassertion.
			0x04		Data transfer length error reported by SPC
			0x05		SPC did not generate an interrupt request
			0x06		SPC interrupt was not detected at the Interrupt
					Request Controller
			0x07		The SPC interrupt was cleared while clearing
					the Interrupt Request Controller.
			0x08		SPC interrupt/step code did not report Diag-
					nostic Self-Test passed

DIAGNOSTIC TESTS AND ERROR CODES

April 1997 CG00000-011503 REV. A F-45