Fujitsu M2488 manual Diag Result Data, Error Reset

M2488 PRODUCT GUIDE MTU DIAGNOSTIC SPECIFICATIONS

ERROR RESET

	:	name	:	code
DIAG command code	:	ERROR RESET command	:	0x70 or 0xF0
DIAG parameter 1	:		:
DIAG parameter 2	:		:
DIAG parameter 3	:		:
DIAG parameter 4	:		:
DIAG parameter 5	:		:
DIAG parameter 6	:		:
DIAG parameter 7	:		:
DIAG parameter 8	:		:
DIAG parameter 9	:		:
execute time	:		:
stop time	:		:
execute count	:		:
reserve	:		:

H-6 DIAG RESULT DATA

The MTU DIAG execution result takes up 512 bytes.

Explanation

The DIAG execution result data is divided into groups. Each group requires 32 bytes. The result data is stored in an area corresponding to the DIAG group executed under the SEND DIAGNOSTIC command.

struct diag result {

unsigned short error code;

unsigned short diag result data[15];

}diag output parm [16]; error code : 0x0000 ------ Normal end error code : 0xFF00 ------ Break end

error code : 0x00XX ------ Error end ( XX : Error code )

The DIAG result data format is shown as follows:

DIAG result format

Result of Loading time (“M1:LOAD”)

		:	measurement result	: unit
0- 1	error code	:		:
2- 3	result data 1	:	Loading time	: 1/10 sec
4- 5	result data 2	:	Clutch winding time	: 1/10 sec
6- 7	result data 3	:	Threading time	: 1/10 sec
8- 9	result data 4	:	BOT shaking time for normal CTG	: 1/10 sec
10- 11	result data 5	:	BOT shaking time for E-CTG	: 1/10 sec
12- 13	result data 6	:		:
14- 15	result data 7	:		:

April 1997 CG00000-011503 REV. A H-21