Fujitsu M2488 manual Online Diagnostic Results data Parameter List

M2488 PRODUCT GUIDE TAPE UNIT SCSI COMMANDS

4-3.19.3 Diagnostic Parameter List (PF=0 in SEND DIAGNOSTIC command CDB)

If the Page Format (PF) bit was cleared to 0 in a previous SEND DIAGNOSTIC command, the RECEIVE DIAGNOSTIC RESULTS command will return diagnostic result data in parameter list format.

Table 4-82. Online Diagnostic Results data Parameter List

								BITS
	BYTES	7		6	5		4		3	2	1	0
	0				Routine in error (Routine number)
	1					Execute Count (Pass Count)
	2-3					First Fault Symptom Code
	4-5					Second Fault Symptom Code
	6-7					Third Fault Symptom Code
	8-15							Reserved
	Description of fields in Diagnostic Results data in Parameter List
			Table 4-83. Parameter List Field Description
BYTE	BIT	VALUE							DESCRIPTION
0	0-7			The Routine in Error field contains the Routine ID of the failing routine. If this field
				contains 00h, no errors were detected during the last execution of a SEND DIAG-
				NOSTIC command.
1	0-7			The Execute Count field contains the number of passes attempted before an error
				was detected. If an error is detected on the first pass, this field contains a 1. This field
				is reset each time a new (different) routine is started. For example: if the SEND
				DIAGNOSTIC command Parameter list contained a pass count of 4 for Routine 50,
				and a pass count of 7 for Routine 51, and an error was detected on the third attempt
				to execute Routine 51, this field would contain a 3.
2-7	0-7			This field contains the Fault Symptom Codes that indicate the cause of the error.

4-3.19.4 RECEIVE DIAGNOSTIC RESULTS CHECK CONDITION Status

If the initiator does not send a SEND DIAGNOSTIC command first, the command is terminated with GOOD status and the target does not transfer any result data.

All reserved bits must be zero. If these bits are set to one, the command is terminated with CHECK CONDITION status and the sense key is set to ILLEGAL REQUEST.

April 1997 CG00000-011503 REV. A 4-87