Fujitsu M2488 manual Recover Buffered Data Sense Keys, Sense KEY Condition Description

TAPE UNIT SCSI COMMANDS M2488 PRODUCT GUIDE

4-3.21.4 RECOVER BUFFERED DATA Sense Keys

One of the following sense keys may be returned if a CHECK CONDITION was indicated:

SENSE KEY	CONDITION		DESCRIPTION
0h	NO SENSE	1. SILI and Fixed bits are both zero and the actual length of the
			block transferred is different from the specified Transfer length
			field of the CDB.
		2.	Filemark encountered during the recover buffered data opera-
			tion.
		3.	More blocks are requested to be transferred than are contained
			in the buffer
4h	HARDWARE ERROR	Transfer of data to initiator failed due to hardware failure
5h	ILLEGAL REQUEST	1. Reserved bit was found set in the CDB.
		2.	The Fixed bit was set to one, but the current mode is variable
			(as defined by the current Mode Select state).
		3.	The SILI and Fixed bits are both set to one.
		4.	The Flag bit was set but the Link bit was not set.
6h	UNIT ATTENTION	Indicates the RECOVER BUFFERED DATA command was not
		performed due to one of the following:
		1.	The tape cartridge may have been changed.
		2.	The target has been reset.
		3.	The Mode parameters have been changed by another initiator.
		4.	The version of the microcode has been changed (microcode
			downloaded).
		5.	A cartridge was loaded with a tape length that is too long or too
			short.
Bh	ABORTED COMMAND	RECOVER BUFFERED DATA command was aborted
Dh	VOLUME OVERFLOW	Write of buffered data prior to the RECOVER BUFFERED
		DATA operation failed because physical End-of-Tape has been
		reached.

4-100 CG00000-011503 REV. A April 1997