Fujitsu manual 16. M2488 Tray Mounting

M2488 PRODUCT GUIDE INSTALLATION INSTRUCTIONS

1-6.5.6 Install the M2488 or M2488 with Medium Changer on the Mounting Tray

Refer to Figure 1-14, Figure 1-16 through Figure 1-19 for this procedure.

NOTE: Before inserting, confirm that the inner cover is on the U-type slit of the mounting tray.

STEP ACTION

1If a single drive is used, it must be mounted on the right side.

2Remove the two foot rails from the drive (if installed).

3Attach drive to the inner cover with four screws (p -CG001901-002). If attached, the FACL should be flush with the front of the inner cover.

4Attach the rear of the drive with one screw (r - SW3NA-3x12S-M-NI1A) through the L-type bracket.

5Use the correct faceplate (optional) for either a single or dual drives and attach to drives.

M2488

M2488 drive

Inner Cover

Mounting Tray

Front Panel

Figure 1-16. M2488 Tray Mounting

April 1997 CG00000-011503 REV. A 1-23