Fujitsu M2488 manual Description KEY

ASC/ASCQ				M2488 PRODUCT GUIDE
			Table B-3. ASC and ASCQ Description (by ASC/ASCQ) (Continued)
	ASC/ASCQ		SENSE	DESCRIPTION
			KEY
	28	00	6	Not ready to ready transition (Priority 2)
	29	00	6	Power on, reset, or BUS DEVICE RESET occurred (Priority 1)
	2A	01	6	Mode parameters changed (Priority 5)
	30	00	3	Incompatible medium installed - attempting 36-track writes over 18-track data away from BOT
	30	01	8	Cannot read medium - unknown format
	30	02	3	Incompatible format
			5	Incompatible format
	33	00	3	Tape length error
			6	Tape length error (Priority 3)
	3A	00	2	Not ready, medium not present. NOTE: This ASC/ASCQ can only be generated when feature
				mode FT5, bit 4 (0x10) is set to one as described in the configuration settings in the M2488
				User’s Guide.
	3B	0D	5	Destination medium changer element full
	3B	0E	5	No cartridge or magazine at specified medium changer source element position
	3B	8F	5	First destination medium changer element empty
	3B	90	5	Second destination medium changer element full
	3B	91	5	Second destination medium changer element empty
	3B	92	5	Medium changer transport element full
	3B	93	5	Medium changer element is not accessible
	3B	94	5	Drive is full, operation cannot be performed
	3D	00	5	Invalid bits in IDENTIFY message
	3F	01	6	Microcode has been changed (Priority 4)
	43	00	B	Message reject error
	44	00	1	Recovered internal hardware error
			4	Hardware error
			B	Internal target failure
	45	00	B	No initiator response to reselection
	47	00	B	SCSI parity error
	48	00	B	Active SCSI command aborted due to an Initiator detected error message being received
	49	00	B	Invalid message error
	4B	00	B	SPC transfer offset error or transfer period error
	4E	00	B	Overlapped commands attempted
	53	00	2	Unload failure
			3	Load failure occurred and buffered write data exists
	53	01	2	Unload failure
			3	Manual unload failure occurred and buffered write data exists
	5B	02	1	Log counter at maximum
	A0	xx	0	Internal Software Error: Unsupported ERPA code xx encountered by error processing software.
				Report ERPA code to Product Support Engineer.
		xx	1	Internal Software Error: Unsupported ERPA code xx encountered by error processing software.
				Report ERPA code to Product Support Engineer.

B-4 CG00000-011503 REV. A April 1997