Fujitsu M2488 Table B-2 Action Advised Codes, Table B-3. ASC and Ascq Description by ASC/ASCQ

M2488 PRODUCT GUIDE							ASC/ASCQ
						Table B-2.	Action Advised Codes (Continued)
		ADVISED					DESCRIPTION
	ACTION CODE
		4			Reissue the same command.
		5			Request manual assistance.
		6			Issue log sense commands to read counter pages. Refer to Chapter 4 for information on the log
					sense commands.
		7			The Host operating system must analyze the condition to see if it is acceptable for the processing
					currently being performed. If acceptable, additional action is required prior to continuing pro-
					cessing, e.g.; cause a new tape to be mounted for multi-volume operation.
		8			In the event of a READ REVERSE command, issue a READ command to read forward, then
					issue a SPACE command to space back one block. Otherwise treat as a permanent error.
		9			Report all 44 bytes of SCSI sense data to the Product Support Engineer.
		.
						Table B-3. ASC and ASCQ Description (by ASC/ASCQ)
	ASC/ASCQ			SENSE			DESCRIPTION
				KEY
	00		00	0		No additional sense available
				3		No additional information
	00		01	0		Filemark detected
	00		17	1		Clean Requested. NOTE: This ASC/ASCQ can only be generated when feature mode FT5, bit 5
						(0x20) is set to one as described in the configuration settings in the M2488 User’s Guide.
	00		02	0		End-of-Medium detected
				3		End-of-Medium detected
				D		End-of-Medium detected
	00		04	0		Beginning-of-Medium detected
	00		05	8		Tape void
	04		00	2		Logical unit not ready, cause not reportable
				3		Manual unload and buffered write data exists
	04		01	2		Not ready, in process of becoming ready. NOTE: This ASC/ASCQ can only be generated when
						feature mode FT4, bit 5 (0x20) is set to one as described in the configuration settings in the
						M2488 User’s Guide.
	04		03	2		Load assistance required
				3		Load assistance required and buffered write data exists
	0C		00	1		Recovered write error
				3		Write error
	11		00	3		Unrecovered read error
	14		04	3		Block sequence error
	17		01	1		Recovered read data with retries
	1A		00	5		Parameter list length error
	20		00	5		Invalid command operation code
	21		01	5		Invalid medium changer element address
	24		00	5		Invalid field in CDB
	25		00	5		Logical unit not supported
	26		00	5		Invalid field in parameter list
	27		00	7		Write protected

April 1997 CG00000-011503 REV. A B-3