Fujitsu manual Chapter Tape Unit Parameters, M2488 Product Guide Tape Unit Parameters, Codes

M2488 PRODUCT GUIDE TAPE UNIT PARAMETERS

CHAPTER 5

TAPE UNIT PARAMETERS

5-1 INTRODUCTION

This chapter describes the parameters for the M2488. The following information is located in this chap- ter:

5-2 ADDITIONAL COMMAND INFORMATION ON MTU MODE SELECT AND MODE SENSE COMMANDS

5-3 MTU INQUIRY/CHANGE DEFINITION VITAL PRODUCT DATA PAGES

5-2 ADDITIONAL COMMAND INFORMATION ON MTU MODE SELECT AND MODE SENSE COMMANDS

Table 5-1 lists the page codes supported by the MODE SELECT and MODE SENSE commands.

	Table 5-1. Page Codes
PAGE	DESCRIPTION
CODE
00h	Vendor Unique Parameters
01h	Error Recovery and Reporting Parameters
02h	Disconnect/Reconnect Control Parameters
0Ah	Common Device-Type Control Parameters
10h	Device Configuration Parameters
	(MODE SENSE ONLY) Target returns all supported pages. The pages are
3Fh	returned in the MODE SENSE data in the following order:
	Page 01h, page 02h, page 0Ah, page 10h, page 00h.
	** NOTE **

The current value of non-changeable Mode Parameters must be returned in MODE SELECT command data.

5-2.1 The Parameters Savable Bit (All pages)

When using the MODE SENSE command, a Parameters Savable (PS) bit of one indicates that the mode page can be saved by the target in a non-volatile, vendor-specific location. A PS bit of zero indicates that the supported parameters cannot be saved. When using the MODE SELECT command, the PS bit is reserved.

April 1997 CG00000-011503 REV. A 5-1