Fujitsu M2488 manual Rack-Mount Installation, Tools Required, Adjust the Guide Plate

M2488 PRODUCT GUIDE INSTALLATION INSTRUCTIONS

1-6.5 Rack-Mount Installation

This procedure is for mounting the M2488 tape drive, with or without a medium changer, in the rack- mount tray.

****************

* CAUTION *

****************

	The weight of the equipment may exceed 10kg, use caution when
	mounting the tape drive and medium changer. Installation may
	require two or more service personnel.
	** NOTE **
	Use M4 x 6mm length screws to mount the M2488 on the rack-
	mounting tray.
1-6.5.1	Tools Required
	The following tools are required to install the M2488 in a rack-mount configuration:
	Phillips screwdriver
	Hex wrench (M4)
	Flat-head screwdriver
1-6.5.2	Adjust the Guide Plate
	Refer to Figure 1-13 and Figure 1-14 for this procedure.
	For a single drive configuration, the guide plate must be mounted as the guide for the inner cover
	on the drive mounting side. The drive must be mounted on the right side and use the optional front
	panel.
	For a two drive configuration, the guide plate is not used.
1-6.5.2.1	Inner Cover Mounted to Mounting Tray
	See Figure 1-13 (A).

STEP ACTION

1Insert the inner cover from the front of the mounting tray and push it into the tray until the stopper is locked.

2Align the round bump at the center of the guide plate with the hole of the inner cover. Use two bolts to attach guide plate.

1-6.5.2.2 Inner Cover NOT Mounted to Mounting Tray

See Figure 1-13 (B).

STEP ACTION

1Remove the inner cover from the mounting tray.

2Align the round bump at the center of the guide plate with the hole of the mounting tray. Use two bolts to attach guide plate.

April 1997 CG00000-011503 REV. A 1-19