Fujitsu M2488 manual Log Parameter Format, LOG Parameter Field Description, ETC=0

TAPE UNIT SCSI COMMANDS M2488 PRODUCT GUIDE

Table 4-33. Log Parameter Format

				BITS
BYTES	7	6	5	4	3		2	1	0
0-1				Parameter Code
2	DU	DS=1	TSD=1	ETC=0		TMC=0		Reserved	LP=0
3				Parameter Length = 08h
4-11				Parameter Value

Table 4-34. LOG Parameter Field Description

BYTE	BIT	VALUE	DESCRIPTION
2			Parameter Control Byte
2	0	0b	The LP bit is returned as a 0b to indicate that this parameter is not an
			ASCII list parameter.
2	2-3	00b	The Threshold Met Criteria field (TMC) is returned as 00b.
2	4	0b	The Enable Threshold Comparison bit (ETC) is returned as 0b, indicating
			that threshold comparisons is not enabled.
2	5	1b	The Target Save Disable (TSD) bit is returned a 1b, indicating that the tar-
			get does not provide a target defined method of saving log parameters.
2	6	1b	The Disable Save bit (DS) is returned as a 1b, indicating that the saving
			that of log parameter is not supported.
2	7	0b	This log parameter has not caused a “LOG COUNTERS AT MAXIMUM”
			condition for this page.
		1b	The Disable Update bit (DU) is returned as a 1b if updating of counters
			within this page is currently disabled as a result of a “LOG COUNTERS
			AT MAXIMUM” condition for this log parameter.
3	0-7	08h	The parameter length field specifies the length in bytes of the following
			parameter value.

If the initiator sends a parameter length value that results in the truncation of the parameter value, the target shall terminate the command with CHECK CONDITION status. The sense key is set to ILLEGAL REQUEST with the additional sense code set to INVALID FIELD IN PARAMETER LIST.

4-36 CG00000-011503 REV. A April 1997