Fujitsu M2488 Product Identification Page Page C2h, Controller Target Configuration Settings

TAPE UNIT PARAMETERS M2488 PRODUCT GUIDE

Table 5-28. INQUIRY Data Format VPD Page C1h - Configuration Page (Continued)

BITS

BYTES

7

6

5

4

3

2

1

0

CONTROLLER (TARGET) CONFIGURATION SETTINGS

45

Target ID (S.TAR)

46

SDTR (S.SDT)

47

WDTR (S.WDT)

48-64

Reserved

5-3.8 Product Identification Page - Page C2h

VPD page C2h contains product identification information. The format for VPD page C2h is:

Table 5-29. INQUIRY data format VPD Page C2h - Product Identification Page

						BITS
BYTES	7		6	5		4		3	2	1	0
0		Peripheral Qualifier					Peripheral Device Type = 01h
1					Page code = C2h
2						Reserved
3					Page length = 18h
4-11						Vendor ID
12-19					Controller Product ID
20-27					Logical Unit Product ID

The following fields defined for this page are stored in NVRAM and are maintained across power cycles and resets. These fields correspond to bytes 8 through 31 in the MTU non-VPD INQUIRY data described in the INQUIRY command description. Reference the INQUIRY command descrip- tion for additional information on these fields.

Table 5-30. INQUIRY Data Format VPD Page C0h Field Description

BYTE	BIT	VALUE	DESCRIPTION
4-11			The Vendor ID field contains 8 bytes of ASCII data that is vendor-specific. This field
			corresponds to bytes 8-15 in the MTU non-VPD INQUIRY data described in the
			INQUIRY command description.
12-19			The Controller Product ID field contains 8 bytes of ASCII data that is vendor-specific.
			This field corresponds to bytes 16-23 in the MTU non-VPD INQUIRY data described
			in the INQUIRY command description.
20-27			The Logical Unit Product ID field contains 8 bytes of ASCII data that is vendor-spe-
			cific. This field corresponds to bytes 24-31 in the MTU non-VPD INQUIRY data
			described in the INQUIRY command description.

5-24 CG00000-011503 REV. A April 1997