Fujitsu M2488 manual Receive Diagnostic Results Sense Keys

M2488 PRODUCT GUIDE TAPE UNIT SCSI COMMANDS

4-3.20.5 RECEIVE DIAGNOSTIC RESULTS Sense Keys

One of the following sense keys may be returned if a CHECK CONDITION was indicated:

SENSE KEY	CONDITION		DESCRIPTION
1h	RECOVERED ERROR	Recovery was performed when writing buffered data, before the
		buffered mode operation occurred in RECEIVE DIAGNOSTIC
		RESULTS command.
3h	MEDIUM ERROR	1.	Write of buffered data failed due to a defective tape.
		2.	An attempt was made to write 36-track data on 18-track format-
			ted medium.
4h	HARDWARE ERROR	1.	SCSI interface error occurred due to a hardware failure (e.g.
			transfer of RECEIVE DIAGNOSTIC RESULTS data failed
			due to a hardware failure).
		2.	Write of buffered data failed due to a hardware failure.
5h	ILLEGAL REQUEST	1. Reserved bit was found set in the CDB of the RECEIVE DIAG-
			NOSTIC RESULTS command.
		2. Flag bit in the RECEIVE DIAGNOSTIC RESULTS CDB was
			set and the Link bit was not set.
6h	UNIT ATTENTION	Indicates the RECEIVE DIAGNOSTIC RESULTS command was
		not performed due to one of the following:
		1.	The tape cartridge may have been changed.
		2.	The target has been reset.
		3.	The Mode parameters have been changed by another initiator.
		4.	The version of the microcode has been changed (microcode
			downloaded).
		5.	A cartridge was loaded with a tape length that is too long or too
			short.
Bh	ABORTED COMMAND	RECEIVE DIAGNOSTIC RESULTS command was aborted.
Dh	VOLUME OVERFLOW	Write of buffered data prior to the RECEIVE DIAGNOSTIC
		RESULTS operation failed because physical End-of-Tape has
		been reached.

April 1997 CG00000-011503 REV. A 4-97