Fujitsu M2488 manual Diagnostic Tests and Error Codes

M2488 PRODUCT GUIDE				DIAGNOSTIC TESTS AND ERROR CODES
	Table F-19. Routine 80 - Servo Diagnostic Error Codes (Continued)
ROUTINE	TEST	TITLE	ERROR		DESCRIPTION
			CODE
0x80	0x05	Servo Diag: Tachometer test	0x06		The machine reel turns too slow
			0x08		File reel tachometer phase error in forward
					direction
			0x0A		File reel tachometer phase error in backward
					direction
			0x0D		File reel turns too slow
			0xE3		Servo command was not accepted; sense
					information was built
			0xE4		Servo command was accepted but failed to
					complete within 60 seconds
			0xE5		Servo error occurred that was not reported as
					a diagnostic error.
0x80	0x06	Servo Diag: ACL/FACL test	0x01		The servo command completed in error and
					valid sense information was built. Byte 19 of
					the sense information, which can be found in
					Table (ACL) or Table (FACL), gives a more
					detailed description of the error.
			0xE3		Medium changer not detected; this test cannot
					be run without a medium changer attached.
			0xE4		Magazine eject failed.
			0xE5		Servo reported error occurred during ACL/
					FACL test initialization.
0x80	0x07	Servo Diag: Manual Sensor test	0x80		Servo error reported during Manual Sensor
					test execution.
			0xE3		Medium changer not detected; this test cannot
					be run without a medium changer attached.
0x80	0x08	Servo Diag: Manual ACL test	0x01		Servo error reported during Manual ACL test
					execution.
			0xE3		Medium changer not detected; this test cannot
					be run without a medium changer attached.

DIAGNOSTIC TESTS AND ERROR CODES

April 1997 CG00000-011503 REV. A F-71