Fujitsu M2488 manual Inquiry Data Format Field Description, Byte BIT Value Description

M2488 PRODUCT GUIDE TAPE UNIT SCSI COMMANDS

Table 4-19. INQUIRY Data Format Field Description

BYTE	BIT	VALUE	DESCRIPTION
0	0-4 &		The Peripheral Device Type and Peripheral Qualifier fields identify the physical device
	5-7		currently connected to the logical unit. The Peripheral Qualifier is described in
			Table 4-20 and the Peripheral Device Type is described in Table 4-21. Table 4-22
			shows the possible combinations of peripheral qualifiers and device types generated
			based on which LUN the INQUIRY command is sent to. In the case where INQUIRY
			data byte 0 is 7Fh (i.e. an unknown or no device type is connected to this LUN) the
			logical unit product ID (bytes 24-31) will contain ASCII spaces (20h).
1	0-6	00h	The Device-type Modifier field is not supported and is returned as all zeroes.
1	7	1	The RMB (Removable Medium) bit is set to one indicating that the medium is remov-
			able.
2	0-2	2h	The ANSI-approved version field of 2h indicates this device complies to the ANSI
			SCSI-2 standard (X3.131-1994, version 10L).
2	3-5 &	0	Zero codes in the ISO version and ECMA version fields indicate no compliance is
	6-7		claimed with the ISO version of SCSI (ISO 9316) or the ECMA version of SCSI
			(ECMA-111).
3	0-3	2h	A Response Data Format is set to a value of 2 indicating that this INQUIRY data is
			formatted based on the format specified by the ANSI SCSI-2 standard (X3.131-1994,
			version 10L).
3	6	0	The Terminate I/O Process (TrmIOP) bit is set to zero, indicating the device does not
			support the Terminate I/O Process message.
3	7	0	The Asynchronous Event Notification Capability (AENC) bit is set to zero, indicating
			the device does not support SCSI-2 defined asynchronous event notifications.
4	0-7	63h	The Additional Length field indicates 99 additional bytes of parameters are supplied.
			If the allocation length in the INQUIRY CDB is too small to transfer all of these
			parameters, the additional length is not adjusted to reflect the truncation by the initia-
			tor.
7	0	0	The Soft Reset (SFTRE) bit is set to zero indicating the target does not support the
			Soft Reset option.
7	1	0	The Command Queuing (CmdQ) bit is set to zero indicating the target does not sup-
			port command queuing for this logical unit.
7	3	1	The Linked command (Link) bit is set to one indicating the target supports linked
			commands for this logical unit.
7	4	1	The Synchronous Transfer (Sync) bit is set to one indicating the target supports syn-
			chronous data transfer.

April 1997 CG00000-011503 REV. A 4-21