Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES M2488 PRODUCT GUIDE

DIAGNOSTIC TESTS AND ERROR CODES

Table F-13. Routine 11 - EDRC Data Buffers Diagnostic Error Codes

ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x11	*	All R20 Data Check Diagnostics	0xD0	SPC register initialization failed
			0xE0	SPC did not generate an interrupt request
			0xE1	SPC interrupt was not detected at the Interrupt
				Request Controller
			0xE2	The SPC interrupt was cleared while clearing
				the Interrupt Request Controller.
			0xE3	SPC interrupt/step code did not report Com-
				mand Complete
			0xE4	The SPC interrupt request could not be
				cleared
			0xE5	SPC did not generate an interrupt request
			0xE6	SPC interrupt was not detected at the Interrupt
				Request Controller
			0xE7	The SPC interrupt was cleared while clearing
				the Interrupt Request Controller.
			0xE8	SPC interrupt/step code did not report Diag-
				nostic Self-Test passed
			0xE9	The SPC interrupt request could not be
				cleared
			0x10	At end of test, SPC did not generate an inter-
				rupt request.
			0x11	At end of test, SPC interrupt was not detected
				at the Interrupt Request Controller.
			0x12	At end of test, the SPC interrupt was cleared
				while clearing the Interrupt Request Control-
				ler.
			0x13	At end of test, SPC interrupt/step code did not
				report Command Complete.
			0x14	At end of test, the SPC interrupt request could
				not be cleared.
			0xEF	SPC interrupt request or interrupt/step register
				could not be cleared at the end of the test
0x11	0x01	Write clear 32 bytes walking 1,	0x01	after a write diag operation was initialized in
		mode 1Eh		the spc chip, the SPC-status register did not
				have one of the following:
				SPC_data_trans_rdy, SPC_busy, or
				SPC_data_reg_empty.

F-32 CG00000-011503 REV. A April 1997