Fujitsu M2488 manual ACL Test Two diagnostic tests to check the autoloader

MTU DIAGNOSTIC SPECIFICATIONS			M2488 PRODUCT GUIDE
0x00	- S:LD HM	: Start loading from the loader home position.
0x01	- S:CTG IN	:	Start loading from the cartridge-in position.
0x02	- S:CAR DW	:	Start loading from the carrier-down position.

DIAG parameter 4: For WITH CTG only, select an unloading position from the following:

0x00	- E:TH END	:	Start unloading from the thread end.
0x01	- E:CAR DW	:	Start unloading from the carrier-down position.
0x02	- 1/6 F PT	:	Start unloading from the cartridge-in position.

execute count: Specify an execution count. Specify a command execution count from 1 to 99,999. When 0 is set, the command execution continues with no stop.

H-4.3.3 ACL TEST: Two diagnostic tests to check the autoloader

(Set the tests in detail using the given parameters.)

1)ACL LDUL: Load and unload cartridges sequentially from the top posi- ------- CMD CD : 0x90 tion of the magazine.

2) MAG UPDW: Move the magazine between two position.------- CMD CD : 0x91

The tests can be set using the following parameters:

DIAG parameter 3: For MAGAZINE UP/DOWN test, set the following:

0xXX- STRT Position	: Magazine up-down start position
	ACL type:	0x00	- 0x09	(10 slot type)
		0x00	- 0x04	(5 slot type)
	FACL type:	0x00	- 0x06

DIAG parameter 4: For MAGAZINE UP/DOWN test, set the following:

0xXX- END Position	: Magazine up-down end position.
	ACL type:	0x00	- 0x09	(10 slot type)
		0x00	- 0x04	(5 slot type)
	FACL type:	0x00	- 0x06

execution time: For ACL LOAD/UNLOAD test, set the frequency in use of cleaning cartridge. Cleaning cartridge in cleaning cell is loaded every setting counter. (from 1 to 99,999) Only FACL. If DIAG command code is set “0x90” and execution time is set “999”, cleaning cartridge is loaded one time.

execute count: Specify an execution count. Specify a command execution count from 1 to 99,999. When 0 is set, the command execution continues with no stop.

H-4.3.4 TESTMODE: Diagnostic test to measure operations

(This test has no parameter.)

1)	M1:LOAD:	Measure the cartridge loading time-------	CMD CD : 0x41
2)	M2:TPPFM:	Measure the tape acceleration/deceleration time.-------	CMD CD : 0x42
3)	M3:AC/PS:	Measure the tape access/positioning time.-------	CMD CD : 0x43
4)	M4:MODCH:	Measure the mode change time.-------	CMD CD : 0x44
5)	M5:LOCAT:	Measure the tape locating time.-------	CMD CD : 0x45
6)	M6:REWND:	Measure the tape rewinding time.-------	CMD CD : 0x46
7)	M7:D.S.E:	Measure the DSE time.-------	CMD CD : 0x47
8)	M8:UNLD:	Measure the cartridge unloading time.-------	CMD CD : 0x48
9)	M9:CLEAN:	Measure the cleaning time.-------	CMD CD : 0x49

H-6 CG00000-011503 REV. A April 1997