Fujitsu M2488 manual Combination Running test by combining up to ten commands

M2488 PRODUCT GUIDE MTU DIAGNOSTIC SPECIFICATIONS

H-4.4 COMBINATION : Running test by combining up to ten commands

1)	#:F-READ	Forward read run-------	CMD CD : 0x01
	(Forward read):	It is same “FWD READ” test of READ/WRITE test.
2)	#:B-READ	Backward read run-------	CMD CD : 0x02
	(Backward	It is same “BWD READ” test of READ/WRITE test.
	read):
3)	#:WRITE	Write operation-------	CMD CD : 0x03
	(Write):	It is same “WRITE” test of READ/WRITE test.
4)	#:D.S.E. (DSE):	DSE operation-------	CMD CD : 0x04
		It is same “D.S.E.”test of READ/WRITE test.
5)	#:LOCATE	High-speed tape run to a specified sector-------	CMD CD : 0x05
	(Locate):	It is same “LOCATE” test of READ/WRITE test.
6)	#:REWIND	High-speed tape run to the wrap-1 BOT position-------	CMD CD : 0x06
	(Rewind):	It is same “WRAP1 BOT” test of READ/WRITE test.
7)	#:UNLOAD	Unloading-------	CMD CD : 0x07
	(Unload):
8)	#:LOAD (Load): Loading next tape from a magazine. (only ACL/FACL) -------		CMD CD : 0x08
9)	#:EJECT	Ejection (only ACL/FACL)-------	CMD CD : 0x80
	(Eject):
10)	TAPE PATH:	Tape run between the specified start position and end posi- -------	CMD CD : 0x0B
		tion.
		It is same “TAPE PATH” test of READ/WRITE test.
11)	#:REPEAT	Repetition of run-------	CMD CD : 0x0A
	(Running	This diagnostic test repeats execution of diagnostic test
	repeat):	from a specified test.

The tests can be set using the following parameters:

DIAG parameter 6: Specify a repeat start position.

execute count: Specify an execution count. Specify a command execution count from 1 to 99,999. (When 0 is set, not repeat)

For example:

After end of 5th group, command code is set following:

DIAG command code is set “0x0A” diag_parameter 6 is set “2” execute count is set “3”

This diagnostic test repeats execution of diagnostic test

3 times from group 2 to group 5.

12) #:END	End of run-------	CMD CD : 0x0C
(Running end):	This is end of diagnostic test.	or 0xFF

H-4.5 Error reset command------- CMD CD : 0x70 or 0xF0

If A error is reported by the MTU during diagnostic test, it is necessary to issue this command.

April 1997 CG00000-011503 REV. A H-9