Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES

DIAGNOSTIC TESTS AND ERROR CODES					M2488 PRODUCT GUIDE
	Table F-14. Routine 12 - EDRC Address Bus Diagnostic Error Codes (Continued)
ROUTINE		TEST	TITLE	ERROR	DESCRIPTION
				CODE
0x12		0x02	SDDP-R20 testing 64k sgc-i-	0x07	All the data expected to be transferred out of
			mem, mode 14h		the SPC data fifo was not transferred to the
					SDDP.
				0x08	host data transfer end of transfer was received
					when not expected, check to see if flush is tied
					high to some other signal.
				0x09	host data transfer end of transfer was not
					received when expected, check to see if flush
					is tied low to some other signal.
				0x0A	Host data transfer error detected on the retry
					mode of this test.
				0x0B	A byte for byte miscompare was detected on
					the data bytes stored in the data_buffer.
0x12		0x03	SDDP-R20 testing 16k sgd-i-	0x01	After start of read operation, SPC-status did
			mem, mode 04h		not have SPC-busy and data_ready, possible
					sddp did not send data to spc.
				0x02	Once read operation had started, slow micro-
					code was able to pull data out of spc_data fifo
					faster then sddp could put into data fifo. Pos-
					sible that the data pipe is broken.
				0x03	At end of read operation, the SPC-status
					should be not busy, not data_ready, and
					data_fifo empty.
				0x04	All the data expected to be transferred from
					the SPC data_fifo to the SPC receive_buffer
					was not transferred.
				0x05	A non SUCCESS status was returned from
					the function call rm_host_rd_complt. A error
					was detected in the SDDP_HI-hdxs register.
				0x07	A byte for byte miscompare was detected on
					the data bytes stored in the SPC receive
					buffer.
0x12		0x04	SDDP-R20 testing sgd-de con-	0x01	After start of read operation, SPC-status did
			trols, mode 00h		not have SPC-busy and data_ready, possible
					sddp did not send data to spc.
				0x02	Once read operation had started, slow micro-
					code was able to pull data out of spc_data fifo
					faster then sddp could put into data fifo. Pos-
					sible that the data pipe is broken.
				0x03	At end of read operation, the SPC-status
					should be not busy, not data_ready, and
					data_fifo empty.

F-40 CG00000-011503 REV. A April 1997