Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES

DIAGNOSTIC TESTS AND ERROR CODES				M2488 PRODUCT GUIDE
Table F-12. Routine 10 - EDRC Control Signals Diagnostic Error Codes (Continued)
ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x10	0x08	Read EDRC-NC 3 bytes 00, mode	0x05	A non SUCCESS status was returned from
		04h		the function call rm_host_rd_complt. A error
				was detected in the SDDP_HI-hdxs register.
			0x07	A byte for byte miscompare was detected on
				the data bytes stored in the SPC receive
				buffer.
0x10	0x09	Read EDRC 3 bytes 00, mode 00h	0x01	A host data path end of transfer was not
				detected in the allotted time.
			0x02	when transferring data from the SPC data_fifo
				to the SPC receive_buffer, the SPC-ssig regis-
				ter did not have the expected bits set:
				SCSI_REQ, SCSI_BSY, xfer_phase.
			0x03	when transferring data from the SPC data_fifo
				to the SPC receive_buffer, the SPC-ssig regis-
				ter did not have the expected bits set:
				~SCSI_REQ, SCSI_ACK, SCSI_BSY,
				xfer_phase.
			0x04	All the data expected to be transferred from
				the SPC data_fifo to the SPC receive_buffer
				was not transferred.
			0x05	A non SUCCESS status was returned from
				the function call rm_host_rd_complt. A error
				was detected in the SDDP_HI-hdxs register.
			0x07	A byte for byte miscompare was detected on
				the data bytes stored in the SPC receive
				buffer.
0x10	0x0A	Write EDRC 3 bytes 00, mode	0x01	after a write diag operation was initialized in
		10h		the spc chip, the SPC-status register did not
				have one of the following:
				SPC_data_trans_rdy, SPC_busy, or
				SPC_data_reg_empty.
			0x02	when transferring data from the SPC send
				buffer to the SPC data fifo, the SPC-ssig regis-
				ter did not have the expected bits set:
				SCSI_REQ, SCSI_BSY, xfer_phase.
			0x03	when transferring data from the SPC send
				buffer to the SPC data fifo, the SPC-ssig regis-
				ter did not have the expected bits set:
				~SCSI_REQ, SCSI_ACK, SCSI_BSY,
				xfer_phase.
			0x04	A non SUCCESS status was returned from
				the function call rm_request_wrtbuffer.

F-30 CG00000-011503 REV. A April 1997