Fujitsu M2488 manual Display Mode Selection Bits 10h, Display Sense Keys 10h

	TAPE UNIT SCSI COMMANDS			M2488 PRODUCT GUIDE
		Table 4-13. Display Mode Selection Bits (10h)
	QUALIFIER			DESCRIPTION
	000b	Bytes 0 to 7 or bytes 8 to 15 are displayed based on the instructions in bits 2-4 of the format control byte. The
		message is displayed until the next tape operation starts or until a new DISPLAY command is received.
	001b	If the DISPLAY command is received when there is a cartridge in the MTU, Bytes 0 to 7 or bytes 8 to 15 are
		displayed based on the instructions in bits 2-4 of the control byte. The message is displayed until the car-
		tridge is removed from the MTU or a new DISPLAY command is received. No message is displayed if there
		is no cartridge in the MTU.
	010b	If the DISPLAY command is received when the MTU is in a ready state, nothing happens. If the DISPLAY
		command is received when the MTU is not in the ready state, Bytes 0 to 7 or bytes 8 to 15 are displayed
		based on the instructions in bits 2-4 of the control byte. The attention lamp blinks. The message is displayed
		until the MTU becomes ready.
	011b	Display left unchanged.
	100b	The host message being displayed is cancelled and a unit message is displayed instead.
	101b	Display left unchanged.
	110b	Display left unchanged.
	111b	If the DISPLAY command is received when there is a cartridge in the MTU, Bytes 0 to 7 or bytes 8 to 15 are
		displayed based on the instructions in bits 2-4 of the control byte. The message is displayed until the car-
		tridge is removed. After the cartridge is removed and until the next cartridge is loaded and becomes ready,
		only bytes 8 to 15 are displayed. The display flashes. The attention lamp blinks.
4-3.4.3		DISPLAY Sense Keys (10h)
		One of the following sense keys may be returned if a CHECK CONDITION was indicated:
	SENSE KEY	CONDITION		DESCRIPTION
	1h	RECOVERED ERROR	Recovery was performed while writing buffered data before the DIS-
			PLAY was received.
	3h	MEDIUM ERROR	1.	Write of buffered data failed due to a defective tape.
			2.	An attempt was made to write 36-track data on 18-track formatted
				medium.
	4h	HARDWARE ERROR	1.	Write of buffered data failed due to a hardware failure.
			2.	SCSI interface error occurred due to hardware failure (i.e. unable to
				transfer display parameters)
			3. The display panel is currently in use displaying check information for
				the operator.
	5h	ILLEGAL REQUEST	1. Reserved bit was found set in the CDB of the DISPLAY command.
			2.	Flag bit was set and Link bit was not set.
			3.	The parameter list length is neither 0 nor 16.
	6h	UNIT ATTENTION	Indicates the DISPLAY command was not performed due to one of the
			following:
			1.	The tape cartridge may have been changed.
			2.	The target has been reset.
			3.	The Mode parameters have been changed by another initiator.
			4.	The version of the microcode has been changed (microcode down-
				loaded).
			5.	A cartridge was loaded with a tape length that is too long or too short.

4-14 CG00000-011503 REV. A April 1997