Fujitsu M2488 manual Table D-2. Formatter Error Recovery

M2488 PRODUCT GUIDE			FAULT SYMPTOM CODES
		Table D-2. Formatter Error Recovery (Continued)
				BYTES
	F.S.C. #	DESCRIPTION	E.R.P.A.	29-39
				GROUP
	8710	PHOK not reset after RDEND	25	04
	8720	Invalid TM, WRAP or ERS	25	04
		RSVP reports unexpected mark
	8730	ERASE error recovery failure	25	04
	8780	PHOK time-out after DBOB	23	01
	8810	Block not found (error block)	44	08
	8820	Backward search Retry Count expired	44	08
	8830	Forward search Retry Count expired	44	08
	8841	Wrap signal lost on Read	23	04
	8842	No continuous found on Read wrap	23	04
	8843	Not enough total wrap mark detected on Read	23	04
	8900	Can’t reset timer carry signal	25	03
	8910	Can’t reset WBEND	25	03
	8920	Can’t reset WCNE	25	03
	8940	WBEND not on before prescribed time at WIDS	25	03
	8950	WBEND time-out	25	03
	8A30	Back into BOT	39	08
	8A40	Invalid command	2E	08
	8E00	End of Data Mark	36	04
	8E2F	Slow or no GAP OUT acknowledge	47	03
	8E30	GAP OUT up before setting	47	03
	8E31	GAP OUT did not reset	47	03
	8E80	Locate Parm error	44	08
	9000	Slow begin	25	04
	9001	Slow end before DPOST (WRITE)	25	04
	9002	Slow end before IBG	25	04
	9004	Can’t detect DBOB at IDS write	25	04
	9005	Can’t detect DIBG at IDS write	25	04
	9006	4 Meter Tones - Erase Gap tone dropout	23/25	04
	9007	4 Meter Tones - IBG tone dropout	23/25	04
	9008	4 Meter Tones - Tape Mark tone dropout	23/25	04

April 1997 CG00000-011503 REV. A D-3