Fujitsu M2488 manual Tape Stopped During Threading, Tape Wound on Take-up Reel

M2488 PRODUCT GUIDE MAINTENANCE AND SERVICING

8-10.2 Tape Stopped During Threading

STEP ACTION

1Remove the DTC as described in paragraph 8-11.6.

2Confirm that the tape is not wound into the machine reel.

3Remove the Threader Assembly as described in paragraph 8-11.7

4Remove the leader block from the threader pin.

5Lay the drive on its left side (when viewed from front).

6Store the leader block into the cartridge by turning the file reel motor (on bottom as shown below) with a phillips screwdriver.

8-10.3 Tape Wound on Take-up Reel

STEP ACTION

1Remove the DTC as described in paragraph 8-11.6.

2Lay the drive on its left side (when viewed from front).

3Turn the file reel motor (on bottom as shown above) counterclockwise with a phillips screwdriver.

4Do not exceed 1.25 kg-cm torque equal to 250 g for tape). Rewind the tape slowly and carefully until the leader block is exposed on the take-up reel.

5Move back threader by pushing bearing, following the groove until the leader block comes out of the take-up reel.

6Rewind the tape by turning the file reel motor counterclockwise with a phillips screwdriver.

7Push the threader bearing so that the leader block seats in the tape cartridge.

April 1997 CG00000-011503 REV. A 8-37