Fujitsu M2488 manual Diagnostic Tests and Error Codes

M2488 PRODUCT GUIDE				DIAGNOSTIC TESTS AND ERROR CODES
	Table F-11. Routine 9 - PCC Timers Diagnostic Error Codes (Continued)
ROUTINE	TEST	TITLE	ERROR		DESCRIPTION
			CODE
0x09	0x03	PCC Timers Timer 2 test	0x02		FMT counter 2 low count carry-out bit not set
			0x03		Timer 2 running too FAST compared against
					FMT counter 2.
			0x04		Timer 2 running too SLOW compared against
					FMT counter 2.
	Table F-12. Routine 10 - EDRC Control Signals Diagnostic Error Codes
ROUTINE	TEST	TITLE	ERROR		DESCRIPTION
			CODE
0x10	*	All R20 Control Check Diagnos-	0xD0		SPC register initialization failed
		tics
			0xE0		SPC did not generate an interrupt request
			0xE1		SPC interrupt was not detected at the Interrupt
					Request Controller
			0xE2		The SPC interrupt was cleared while clearing
					the Interrupt Request Controller.
			0xE3		SPC interrupt/step code did not report Com-
					mand Complete
			0xE4		The SPC interrupt request could not be
					cleared
			0xE5		SPC did not generate an interrupt request
			0xE6		SPC interrupt was not detected at the Interrupt
					Request Controller
			0xE7		The SPC interrupt was cleared while clearing
					the Interrupt Request Controller.
			0xE8		SPC interrupt/step code did not report Diag-
					nostic Self-Test passed
			0xE9		The SPC interrupt request could not be
					cleared
			0x10		At end of test, SPC did not generate an inter-
					rupt request.
			0x11		At end of test, SPC interrupt was not detected
					at the Interrupt Request Controller.
			0x12		At end of test, the SPC interrupt was cleared
					while clearing the Interrupt Request Control-
					ler.

DIAGNOSTIC TESTS AND ERROR CODES

April 1997 CG00000-011503 REV. A F-25