Fujitsu manual ASC/ASCQ M2488 Product Guide, Table B-2. Action Advised Codes

ASC/ASCQ			M2488 PRODUCT GUIDE
		Table B-1. ASC and ASCQ Description (by Sense Key) (Continued)
SENSE	ASC/ASCQ		DESCRIPTION	ADVISED
KEY				ACTION
4	44	00	Hardware error	1
5	1A	00	Parameter list length error	1
	20	00	Invalid command operation code	1
	21	01	Invalid medium changer element address	1
	24	00	Invalid field in CDB	1
	25	00	Logical unit not supported	1
	26	00	Invalid field in parameter list	1
	30	02	Incompatible format	8
	3B	0D	Destination medium changer element full	1
	3B	0E	No cartridge or magazine at specified medium changer source element position	1
	3B	8F	First destination medium changer element empty	1
	3B	90	Second destination medium changer element full	1
	3B	91	Second destination medium changer element empty	1
	3B	92	Medium changer transport element full	1
	3B	93	Medium changer element is not accessible	1
	3B	94	Drive is full, operation cannot be performed	1
	3D	00	Invalid bits in IDENTIFY message	1
6	28	00	Not ready to ready transition (Priority 2)	7
	29	00	Power on, reset, or BUS DEVICE RESET occurred (Priority 1)	7
	2A	01	Mode parameters changed (Priority 5)	7
	33	00	Tape length error (Priority 3)	7
	3F	01	Microcode has been changed (Priority 4)	7
7	27	00	Write protected	5,4
8	00	05	Tape void	1
	30	01	Cannot read medium - unknown format	1
B	43	00	Message reject error	1
	44	00	Internal target failure	4
	45	00	No initiator response to reselection	1
	47	00	SCSI parity error	1
	48	00	Active SCSI command aborted due to an Initiator detected error message being re-	1
			ceived
	49	00	Invalid message error	1
	4B	00	SPC transfer offset error or transfer period error	4
	4E	00	Overlapped commands attempted	1
D	00	02	End-of-Medium detected	1

Table B-2. Action Advised Codes

ADVISED

ACTION CODE

DESCRIPTION

1

Treat the error as a permanent error.

2

Execute Dynamic Device Reconfiguration (DDR).

3

Continue processing.

B-2 CG00000-011503 REV. A April 1997