Fujitsu manual Prepare the M2488 Tape Drive

M2488 PRODUCT GUIDE INSTALLATION INSTRUCTIONS

1-6.6.1 Prepare the M2488 Tape Drive

Refer to Figure 1-20, Figure 8-6 and Figure 8-7 during performance of this procedure.

STEP ACTION

1Remove two screws from each of the foot rails on the bottom of the drive, then remove the foot rails. See Figure 8-7.

2Remove the top cover by removing the two screws from the left and right side, and the two screws on the rear. Pull the cover up from the rear and slide backwards. See Figure 8-6.

****************

* CAUTION *

****************

Remove the top cover by lifting the front of the top cover BEFORE sliding it backwards. Ensure that the cover does not catch on the components on the PCBA under the top cover.

3Remove the four screws from the sides of the front panel, then gently pull the front panel forward.

4Disconnect the operator panel cable from the front panel.

5Remove the two screws holding the panel bracket, then pull off the panel bracket.

Figure 1-20. Prepare the M2488 Tape Drive

April 1997 CG00000-011503 REV. A 1-27