Sega WaveRunner owner manual 17 2 Error Message, Display Network Error no Master Site Cause, Slave

17 - 2 ERROR MESSAGE

￿This work should be performed by the Location's Maintenance Man or Serviceman. Performing work by non-technical personnel can cause accidents.

￿Should any errors other than listed by this manual or by NAOMI Service Manual occur, contact where the product was purchased from or an office described in this manual. Failing to comply with this instruction can cause accidents.

This product displays the error on the screen if the faulty is detected. If an error is displayed, be sure to take action against it according to the appropriate cause and countermeasures listed below.

It may be displayed the error other than listed by this manual or by NAOMI Service Manual. In that case, contact where the product was purchased from or an office described in this manual without operating it selfishly.

DISPLAY	NETWORK ERROR: NO MASTER SITE
CAUSE	No MASTER setting in Communication Mode.
COUNTERMEASURES	Perform the Communication Mode setting in the Game Assign-
	ments. Set one of the machines to MASTER and all others to
	SLAVE. (9-3 d) (20-3)
DISPLAY	NETWORK ERROR: DUPLICATE MASTER SITE
CAUSE	MASTER setting is duplicated in Communication Mode.
COUNTERMEASURES	Perform the Communication Mode setting in the Game Assign-
	ments. Set one of the machines to MASTER and all others to
	SLAVE.
DISPLAY	NETWORK ERROR: NO SLAVE SITE
CAUSE	No SLAVE setting in Communication Mode.
COUNTERMEASURES	Perform the Communication Mode setting in the Game Assign-
	ments. Set one of the machines to MASTER and all others to
	SLAVE. (9-3 d) (20-3)
DISPLAY	NETWORK ERROR: TOO MANY NODES SITE
CAUSE	Too many machines are connected.
COUNTERMEASURES	Up to 4 machines can be connected to allow to enjoy communica-
	tion play.
DISPLAY	NETWORK ERROR: DUPLICATE CABINET ID
CAUSE	The number of Cabinet ID is duplicated in Communication Mode.
COUNTERMEASURES	Change the number of Cabinet ID for every seat in the Game As-
	signments. (9-3 d) (20-3)
DISPLAY	DRIVE BD ERROR: E2H
CAUSE	The Ride is not centering with the right value.
COUNTERMEASURES	Ensure that the Ride is slanted or the connector of ASSY Wire
	Tube is connected securely. (Section 6)

101www.seuservice.com