11. MAINTENANCE OF MECHANISM UNIT

In order to prevent an electric shock and short circuit, be sure to turn power off before performing work by touching the interior parts of the product. Be careful so as not to damage wirings. Damaged wiring can cause an electric shock or short circuit accident.

After the power is turned off, close the Main Cock, and then start working. The Main Cock not closed can cause serious accidents resulting from cylinder movement, etc., due to some cause.

Periodically retighten the designated bolts. Continuing business operation with the bolts as is loosened can cause serious accidents.

When assembling, be sure to perform the work by plural persons. Depending on the assembly work, there are some cases in which performing the work by a single person can cause personal injury.

Do not touch undesignated places. Touching places not designated can cause electric shock or short circuit.

This work should be performed by the Location's Maintenance Man or Serviceman. Performing work by non-technical personnel can cause electric shock hazard.

Do not insert hand into the mechanism so as not to cause hand and fingers pinched in. Failure to observe this can cause a serious injury such as a fracture.

When performing work such as parts replacement other than those specified in this manual, be sure to contact where you purchased the product from and confirm the work procedures and obtain precautions prior to performing work. Inappropriate parts replacement and/or installing with erroneous adjustment can cause an overload or the parts to come into contact, resulting in an electric shock, a short circuit, and a fire.

Immediately replace the important parts, which are intended for hazard prevention, if damaged or omitted. Non- replacement of these parts can cause accidents.

Hot Compressor can cause burn. After turning the power off, wait until the high temperature portions cool off to start working.

The mobile parts of this machine need greasing once every 6 months. At the same time, retighten each installation bolts. Perform the above maintenance work after removing each Lid and the Bellows Brackets, as per the following procedure.

63www.seuservice.com

Page 72
Image 72
Sega WaveRunner owner manual Maintenance of Mechanism Unit