Replacing the Throttle Volume

5Moving the Volume Bracket causes Adjust Gear mesh to be disengaged.

6Adjust gear mesh and tighten the 2 Nuts.

7Grip the Throttle Lever and check to ensure that the V. R. value variations are within the rotatable range of the Volume Shaft.

8After finishing adjustments, be sure to perform Throttle Volume setting on the Volume Setting screen in the Test mode (see 9 - 3e).

1Turn the power off.

2 Perform the above adjustment procedure 1 ~ 3 .

3Disconnect the connector connected to the Throttle Volume. (PHOTO 12. 1 d)

THROTTLE VOLUME

220-5373,5484

CONNECTOR (1)

BLACK 3P

PHOTO 12. 1 d

4Take out the 2 Nuts which secure the Volume Bracket, and remove the Volume Bracket with the Volume as is attached.

5Remove the Volume Gear from the Volume Shaft, and replace the Volume by removing from the Bracket.

6After the replacement, perform Volume Setting in the Test mode (see 9 - 3e).

Sega WaveRunner owner manual Replacing the Throttle Volume