TABLE 17 b
PROBLEMS | CAUSE | COUNTERMEASURES | |
|
|
| |
During game, the Ride does | Deviation of Handle Volume. | Adjust the Volume value in the test mode. (See | |
not turn when the |
|
| |
| Replace the Volume. (See | ||
Handlebars are turned. | Malfunctioning of Handle Volume. | ||
|
|
| |
When gripping the Throttle | Deviation of Throttle Volume. | Adjust Volume values in the Test mode. (See | |
Lever, the Ride does not |
|
| |
| Replace the Volume. (See | ||
advance. | Malfunctioning of Throttle | ||
| Volume. |
| |
|
|
| |
Vertical movements of the | Initial setting is wrong. | Turn power off and then turn it back on again to perform | |
Ride during game is weak |
| initial setting movement. (See 6 Section 6) | |
and irregular. |
|
| |
Malfunctioning of Pitch Volume. | Replace Volume. (See | ||
| |||
|
|
| |
| Preset pressure is incorrect. | Make pressure adjustment. (See | |
|
|
| |
| Air leakage. | Check the Air Drive System. | |
|
|
| |
| Communication fault between the | Check in the wiring test. (See | |
| I/O BD and Drive BD. |
| |
|
|
| |
| Air Damper adjustment fault. | Air Damper adjustment. (See the end of this Section) | |
|
|
| |
Left/right movements of the | Deviation of Roll Volume. | Adjust Volume values in the Test mode. (See | |
Ride is weak and irregular. |
|
| |
Preset pressure is incorrect. | Make pressure adjustment. (See | ||
| |||
|
|
| |
| Air leakage. | Check the Air Drive System. | |
|
|
| |
| Communication fault between I/O | Check in the wiring test. (See | |
| BD and Drive BD. |
| |
|
|
| |
| Malfanctioning of Inclination | Replace the Inclination Sensor. (See | |
| Sensor. |
| |
|
|
| |
Communication play not | Communication cable connection is | Connect the communication cables correctly. (See | |
possible. | incorrect. |
| |
|
|
| |
| Communication settings are wrong. | Correct the settings. (See | |
|
|
| |
Fluorescent lamp doesn't | Connector connection fault. | Check connector connections between the Billboard and | |
light up. |
| PTV. (See Section 6) | |
|
|
| |
| Fluorescent lamp need replacement. | Replace the fluorescent lamp. (See Section 15) | |
|
|
|
CIRCUIT PROTECTOR
CIRCUIT PROTECTOR
Functions due to the activation of bimetal. To restore the function, wait for approximately one minute or longer until the bimetal cools off. (Press the Button.)
www.seuservice.com | 98 |
