CONVERGENCE ADJUSTMENT (manual color matching)
STOP
IMPORTANT!
To avoid circuitry malfunctioning due to electrical load increase, never utilize CONVERGENCE ADJUSTMENT (Line Convergence Adjustment in particular) for adjusting screen size changes.
There is no means to restore the Convergence Adjustment data once stored, to its original state. To avoid changing the screen size by erroneously using convergence adjustment, do not perform the green Line Convergence Adjustment.
As such, be sure to perform the adjustment work from this page onward by the Technical staff and the location's Maintenance Personnel who are well versed in such adjustment work. In the Static Convergence Adjustments, if satisfactory adjustments can not be performed, do not make another convergence adjustments inadvertently. Contact the office herein stated or where the product was purchased from.
To avoid making the adjustment work ineffective, do not press the RESET button during adjustment.
To discontinue adjustment work, keep pressing the TEST button for approximately 3 seconds at the stage before storing the adjustment data by pressing the WRITING button.
Should the screen be abnormally disturbed by noise due to static electricity, etc., turn the power off without storing the adjustment data.
Pressing the 
or 
PIC - ADJ button in the Convergence Adjustment mode status will display the Adjustment Menu shown right. Do not utilize this Adjustment Menu as this is the one applied at the factory.
Adjusting this menu causes the Customer's adjustment range to be deviated.
Should the menu shown right be
displayed by mistake, first choose EXIT by using either 
or 
PIC - ADJ button and then press the SET button.
ADJUST MODE
SUB VSIZE
SUB HSIZE
SUB BRIGHT
EXIT
Adjustment menu used in the factory.
91 | www.seuservice.com |
