3

SECURING IN PLACE (ADJUSTER ADJUSTMENT)

Make sure that all of the adjusters are in contact with the floor. If they are not, the cabinet can move and cause an accident.

This product has 8 casters (4 for FRONT CABINET, 4 for REAR CABINET) and 8 Adjusters (4 for FRONT CABINET, 4 for REAR CABINET). (FIG. 6. 3a) When the installation position is determined, cause the adjusters to come into contact with the floor directly, make adjustments in a manner so that the casters will be raised approximately 5mm from the floor and make sure that the machine position is level.

CASTER

1Transport the product to the installation position. Be sure to

provide adequate space allowing the player to get on and off.

2Have all of the Adjusters make contact with the floor. Adjust the Adjuster's height by using a

wrench so that the machine position is kept level.

3After making adjustment, fasten

the Adjuster Nut upward and

 

ADJUSTER

secure the height of Adjuster

FIG. 6. 3 a BOTTOM VIEW

(FIG. 6. 3 b).

 

 

ADJUSTER

CASTER

FASTEN UPWARD.

Approx.5mm

ADJUSTER

FIG. 6. 3 b ADJUSTER

FIG. 6. 3 c

Refer to this Fig. (Scale:1/100) for the layout of the place of installation.

10cm 15cm

FIG. 6. 3 d

Be sure to provide space as shown between the Air Vent and the wall surface.

www.seuservice.com22

Page 31
Image 31
Sega WaveRunner owner manual Secure the height of Adjuster