www.seuservice.com 86AUTOMATIC COLOR MATCHING
The Projector may be subject to color deviations affected by earth magnetism, the building steel
frames, etc. When the Projector is initially installed or the Projector's installation position is
changed, have the color matching performed automatically.
Keep pressing the P button (red) for approximately 3 seconds to have
the ensuing movements performed automatically.
TEST MODE WRITING
POSITION
ADJUST
SELECT
RESET
RBG
PIC-ADJ
SET
P
When the green cross pattern movements are finished, similar detection
is performed sequentially in order of red and then blue cross move-
ments. After detecting by green, red and blue cross movements, the
game mode returns with the color deviation status being corrected.
Although very rarely, the TRY AGAIN error display in red may appear. At this time, press the
P button (red) for approximately 3 seconds.
Even after the above operation is repeated, if the error condition still exists, then the display
shifts to PLEASE ADJ. In this case, the auto color matching function can not be used. Contact
the place of contact herein stated or where the product was purchased from.
If the automatic color matching indicates an error, color matching can manually be performed.
Refer to CONVERGENCE ADJUSTMENT (manual color matching).
The Projector will shift to the color deviation
correction mode from the game mode, with
the green cross pattern appearing on the
screen.
The cross pattern moves up/down and right/
left to start the movement of searching the cor-
rect screen position and inclination.
1