Zebra Technologies 105Se manual URQW3DQHO/LJKWV, 02.H, Indicator Light Name Status Indication

02'(￿.H\

The MODE key puts the printer in configuration mode. In this mode, you can adjust the print darkness, media tear-off position, and label top position, or perform a calibration. See “Configuration and Calibration” beginning on page 39 for more information.

)URQW￿3DQHO￿/LJKWV

Refer to Figure 11 for the location of the lights.

Note:	If an operating condition which causes a light to be ON
	constantly and one which causes the same light to flash occur
	simultaneously, the light flashes.
Indicator Light Name		Status	Indication
POWER		ON	Printer is on.
		OFF	Normal operation
			Head Over Temperature condition. Printing stops until the
		ON	printhead cools down. Printing resumes automatically.
PRINTHEAD			Printhead Under Temperature condition. Printing
			continues.
			Power Supply Over Temperature condition. Printing stops
			until the power supply cools down. Printing resumes
			automatically.
		Flashing	Printhead Open.
		OFF	Media and ribbon (if used) are properly loaded.
PAPER/RIBBON		ON	Paper out.
			1. In Thermal Transfer Mode: Ribbon is out.
		Flashing
			2. In Direct Thermal Mode: Ribbon is in the printer.
		OFF	Normal operation.
PAUSE
		ON	Printer has stopped all printing operations.
		OFF	Normal operation.
		ON	Labels are printing.
DATA		Single Flash	The CANCEL key was pressed and a format was
			successfully deleted from the print queue.
		Flashing	Receiving data from host computer.
		Slow Flashing	Printer sent a “stop transmitting” command to the host
			computer.
DARKEN		ON
			Printer is in the Configuration Mode. See page 42 for
POSITION		ON
			more information.
CALIBRATE		ON

Zebra S-Series User’s Guide 27