Zebra Technologies 105Se manual $GMXVWLQJWKH3ULQWDUNQHVV, $GMXVWLQJWKH0HGLD5HVW3RVLWLRQ

$GMXVWLQJ￿WKH￿3ULQW￿'DUNQHVV

This procedure sets the darkness of the printing on the label. Use the lowest setting that provides the necessary print quality.

1.Press the MODE key. PAUSE and DARKEN lights turn ON.

2.Press UP or DOWN to adjust the current setting.

3.Press the MODE key three times. The MODE lights flash ON and OFF to indicate that the settings have been saved in memory.

4.Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.

$GMXVWLQJ￿WKH￿0HGLD￿5HVW￿3RVLWLRQ

This procedure sets the end-of-label position relative to the tear-off bar or cutter.

1.Briefly press the MODE key twice. PAUSE and POSITION lights turn ON.

2.Press UP or DOWN to adjust the current setting.

3.Briefly press the MODE key twice. The MODE lights flash ON and OFF to indicate that the settings have been saved in memory.

4.Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.

$GMXVWLQJ￿WKH￿3RVLWLRQ￿RI￿WKH￿7RS￿RI￿WKH￿/DEHO

This procedure positions the printing on the label relative to the top edge of the label.

1.Briefly press the MODE key twice, then press and hold for about five seconds until the lights change. PAUSE, DARKEN, and CALIBRATE lights turn ON.

2.Press UP or DOWN to adjust the current setting.

3.Briefly press the MODE key twice. The MODE lights flash ON and OFF to indicate that the settings have been saved in memory.

4.Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.

44 Zebra S-Series User’s Guide