5HPRYLQJ￿8VHG￿5LEERQ￿￿￿￿￿6￿

Refer to Figure 10.

1.Turn the knob at the end of the ribbon take-up spindle (1) clockwise until it stops. This causes the ribbon release bars to pivot down (2), easing the spindle’s “grip” on the wound ribbon.

2.Slide the ribbon off of the ribbon take-up spindle. Once the used ribbon has been removed, ensure that the arrow on the knob aligns with the indented notch in the ribbon take-up spindle (see inset).

3.Remove the empty core from the ribbon supply spindle.

4.Follow the ribbon loading procedure on page 14 to load the new ribbon.

Figure 10

20

Zebra S-Series User’s Guide

Page 28
Image 28
Zebra Technologies 105Se manual 5HPRYLQJ8VHG5LEERQ6