7HDU￿2II￿0RGH

Follow the instructions described in “Roll Media” on page 15.

5HZLQG￿0RGH

Note: Rewind option required.

To initially configure the printer for this mode, follow these steps:

1.Remove the media rewind plate from its storage location in front of the printhead inside the media compartment.

2.Invert the rewind plate so that the lip on the attached hook plate points down.

3.Insert the hook plate lip a short distance (1/2") into the lower opening in the side plate.

4.Align the upper end of the rewind plate with the corresponding opening in the side plate and slide the rewind plate in so that it stops against the main frame.

5.Remove the hook from the take-up spindle shaft.

6.Route the media as shown in Figures 5 and 6 and wind it 1-2 times around a 3" core.

3HHO￿2II￿0RGH

1.Remove the rewind plate if one is present and store it on the two mounting screws on the inside of the front panel. Align the notch or web in the media so that the take label sensor can sense a peeled label.

2.Load media as shown in Figures 5 and 6.

3.Remove the hook from the take-up spindle shaft.

4.Remove several labels from the media backing and then wind the backing 1-2 times around the media take-up spindle and reinstall the hook.

Zebra S-Series User’s Guide

17

Page 25
Image 25
Zebra Technologies 105Se manual 7HDU2II0RGH, 5HZLQG0RGH, 3HHO2II0RGH