Zebra Technologies 105Se manual l›c‹à, 9$&3RZHU&RUG

￿®®l›c‹à

￿￿￿￿9$&￿3RZHU￿&RUG

Depending on how your Zebra S-Series printer was ordered, a power cord may or may not be included when the printer is optioned for 230 VAC, 50/60 Hz operation.

If a power cord is not supplied, you need to obtain one with the following specifications:

•The overall length must be less than 3.8 meters.

•It must be rated for at least 5 amps, 250 V.

•The CHASSIS GROUND (EARTH) MUST BE CONNECTED to assure safety and reduce electromagnetic interference. This is done by the third wire in the power cord (see Figure 27).

Figure 27

•The plug cap should bear the certification mark of a known international safety organization (see Figure 28).

Figure 28

Zebra S-Series User’s Guide 83