Zebra Technologies 105Se manual 0HGLD+DQGOLQJ

0HGLD￿+DQGOLQJ

•Tear-Off Mode: Produced in strips.

•Peel-Off Mode: Requires Peel-Off option or Media Rewind option. Labels are dispensed and peeled from the liner, and the liner is rewound internally.

•Rewind Mode: Requires Media Rewind option. A full roll of printed labels is rewound internally.

•Cutter Mode: Requires Cutter Module option. Media cut after printing; under software control.

0HGLD

Media Specifications			105Se		160S
		Maximum	4.5"	114.3 mm	7.2"	182.9 mm
Total media width
		Minimum	0.75"	19.05 mm	2.0"	50.8 mm
	Maximum		Refer to “Printing Considerations” on page 71.
Label length		Tear-Off	0.63"	16.00 mm	0.63"	16.00 mm
	Minimum	Peel-Off	0.50"	12.8 mm	0.50"	12.8 mm
		Rewind	0.50"	12.8 mm	0.50"	12.8 mm
		Cutter	1.25"	31.75 mm	N/A	N/A
	Maximum (Printhead		0.015"	0.381 mm	0.015"	0.381 mm
Total thickness	position may need to be
(includes liner)	adjusted above 0.01”)
	Minimum		0.0023"	0.0584 mm	0.0023"	0.0584 mm
Core size			3.0"	76.2 mm	3.0"	76.2 mm
Maximum roll diameter			8.0"	203.2 mm	8.0"	203.2 mm
Interlabel gap (0.115”/3 mm preferred)			0.079" - 0.157"	2 mm - 4 mm	0.079" - 0.157"	2 mm - 4 mm
Maximum internal fanfold media pack size			8.0" x 7.2" x	203.2 mm x 182.8	8.0" x 7.2" x	203.2 mm x 182.8
(L x W x H)			6.2"	mm x 157.4 mm	6.2"	mm x 157.4 mm
Additional Specifications			for Black	Mark Media	(optional on	105Se)
Mark thickness (measuring		Minimum	0.12"	3 mm	0.12"	3 mm
parallel to label/tag edge)
		Maximum	0.43"	11 mm	0.43"	11 mm
Mark width (measuring		Minimum	0.43"	11 mm	0.43"	11 mm
perpendicular to label/tag edge)
		Maximum	Full media width.		Full media width.
Mark-to-mark registration tolerance			+/-0.016"	+/-0.4 mm	+/-0.016"	+/-0.4 mm
Mark location			Mark must be located on the inside of the media (closest to the printer’s
				mainframe when loaded in the printer).
Mark density				>1.0 ODU (Optical Density Unit)
Density of the back of the media on which the				0.5 ODU maximum
black mark is printed

72 Zebra S-Series User’s Guide