Post Error Codes and Messages List | IBM 2274 specification

Table 2-1 POST Error Codes and Messages List

NOTE: To diagnose a problem, first find the BIOS error messages or codes in left column. If directed to a check procedure, replace the FRU indicated in the check procedure. If no check procedure is indicated, the first Action/FRU listed in right column is the most likely cause.

BIOS Error Codes,		Action/FRU
Messages		Action/FRU
Messages

Floppy Disk(s) Fail (80)	1.	Re-connect floppy disk
		drive
	2.	Enter Configuration/
		Setup Utility and load the
		default settings.
	3.	Floppy disk drive
	4.	System board

Floppy Disk(s) Fail (40)	1.	Re-connect floppy disk
		drive
	2.	Enter Configuration/
		Setup Utility and load the
		default settings.
	3.	Floppy disk drive

Hard Disk(s) Fail (80)	1.	Enter Configuration/
Hard Disk(s) Fail (40)		Setup Utility and load the
		default setting
	2.	Check IDE drive jumper.
		See “3.5-In. Hard Disk
		Drive Jumper Settings”
		on page 117.
	3.	IDE hard disk drive
		power.
	4.	IDE hard disk drive cable/
		connection.
	5.	IDE hard disk drive.
	6.	System board

Hard Disk(s) Fail (20)	1.	Enter Configuration/
Hard Disk(s) Fail (10)		Setup Utility and load the
		default setting
	2.	IDE hard disk drive
		power.
	3.	IDE hard disk drive cable/
		connection.
	4.	IDE hard disk drive.

Hard Disk(s) Fail (08)	1.	Hard disk drive

Check Procedures 43

Image 77

IBM 2274 manual Post Error Codes and Messages List

Contents

Hardware Maintenance Service for Service Level a Page Contents Diagnostic Aids Check ProceduresSystem Backup Battery Electrical input Operating Requirements Parts Catalog Safety Inspection GuideParts/Test Point Locations Index Appendix A. FRU Number ListAppendix B. Online Support Voltage Supply Range Voltage Switch Setting Voltage Supply Switch Settings To Connect To Disconnect Safety Information Do not Para Desconectar Para Conectar Cuidado Cuidado Page Xiv Page Xvi Connexion Déconnexion Xviii Page Kabel anschließen Kabel lö sen Vorsicht Achtung Xxii Instrumenten betrachten und den Strahlungsbereich meiden Per collegare Per scollegare Pericolo Xxiv Attenzione Attenzione Xxvi Page Instrucciones de Conexió n Desconexió n Xxviii Peligro Page Categorie Laser Compliance Statement HelpCenter Trademarks Numbers listed in numerical order PrefaceAppendix A, FRU Number Index contains part Xxxiv General Information Introduction Memory Product OverviewProcessor Hard Disk Drive External PortDiskette Drive Multimedia Power ManagementDVD-ROM Drive Monitor Not included with some models Power SupplyInternal Cabling Mouse Keyboard Interface Hardware Interfaces USB Cmos Reset Power-On Password Flash Bios Update Procedure Type ADMICFG.EXE/ type 01 05 Type BIOS-contained Model Number and Serial Number Working with the Configuration/Setup Utility Menu Bios Configuration/Setup Utility Keys Function Changing Parameter Settings Save & Exit Settings Devices and I/O ports Viewing System Information, and Product Data ECP Mode Use DMA Onboard Parallel ModeOnboard Serial Port Onboard Parallel Port MPU-401 --Enabled IDE Prefetch ModeUSB Mouse Support Onboard Sound Startup Options Keyboardless Operation Setting a Power-On Password Delete Power-On Password Changing the Power-On Password Video Bios Shadow Advanced SetupCPU Internal Cache External Cache Power Management Setup Doze Mode HDD Power DownSuspend Mode PM Control by APM Primary Intr Video Off MethodActivity Monitor RTC Alarm Resume Power On by PCI CardModem Ring Resume Date MonthPage Specifications Operating Requirements Check Procedures Index of Symptoms, Messages, Error Codes, or Start Read the Following Insert diagnostics diskette in the diskette drive 007 005 009 Index of Symptoms, Messages, Error Codes, or Beeps Page Bios Error Codes Action/FRU Messages Post Error Codes and Messages List Post Error Codes and Messages List Post Error Codes and Messages List Post Error Codes and Messages List Bios Error Beeps Action/FRU Bios Error Beeps List System Board and Memory Error Symptoms ListError Symptoms Action/FRU Processor / Processor Fan Diskette Drive Error Symptoms Action/FRU Check Procedures CN6 HDD Hard Disk Drive Error Symptoms Action/FRU CD/DVD-ROM Drive Date and Time on Video and Monitor Parallel/Serial Ports Diagnostic ProgramJoystick Keyboard Other Problems Error Symptoms Action/FRU Power Supply Factory-Installed Storage Devices Troubleshooting Select Utility from the menu 003 005 Page 002 Factory-Installed Modem Card Select an on-line service station, dial and connect to it Select Program, then select Accessories, Hyper TerminalStart Microsoft Windows Select the Start icon Modem adapter functions normally End Audio Not Supported by Diagnostics Program 004 Select Settings, then select Control Panel006 008Page CD/DVD-ROM Drive Replace CD/DVD-ROM drive End IBM Desktop System HMM Replace system board End Follow the screen instructions to run the Memory test Memory Keyboard is functioning normally End KeyboardTry with a known good keyboard Replace the system board End Test right left button and check if right left button works MouseTest mouse cursor movement Mouse is functioned normally End 010 Try with a known good mouseReplace the mouse End 011 Disconnect the power cord from the back of the system unit Power Supply Pin-hole side view Replace the power supply End Check Procedures Replace the on/off switch cable assembly Monitor Is the Screen READABLE? YES, Read AHEAD. NO, GO to Step Dimm Undetermined ProblemsPage IBM Desktop System HMM Diagnostic Aids Introduction Power-On Self Test Page Using the Diagnostic Diskette Diagnostic Diskette Using Diagnostic Program from Recovery CD Submenu Selections Diagnostics Program Features Diagnostic Program Main Menu Selections Repair Information Removals and Replacements Handling ESD-Sensitive Parts Bay Identifying the Parts of the System Unit Power supply Adapter card connectorsAdapter cards Adapter card slots Cover Page Bay Panels Bay 1- 5.25-In. Bay Internal or External Access Page Page Front Panel Power Supply Adapter Cards MemoryDIMM AMD K7 Duron Processor Page System Backup Battery Indicator LED and Cable System Board Page IBM Desktop System HMM Parts/Test Point Locations Parts/Test Point Locations Introduction System Board Jumper Setting System Board Jumpers ConnectorsSystem Board Connector Functions Jumper/Settings Function CN6 Pin Voltage Cable Color Power Supply Connectors and VoltagesPower Supply Output Pin Assignment +5Vdc Green Ground Black No connect Red Network Cards RJ-45 connector is used Accton Parts/Test Point Locations Function Connect to RJ11 connector Telephone line Factory-Installed Modem Card LayoutAskey GVC Factory-Installed Modem Card Connector Functions Nvidia M64 w/ TV Out, 32MB Nvidia NV10 w/ TV Out, 32MB Video Cards Optional output from monitor IBM Desktop System HMM D Signal Pin AssignmentsPin Signal In. Hard Disk Drive Jumper Settings J50 Description Lite-on CD-ROM Drive CD-ROM Emergency-exit option CD-ROM Front Panel Introduction Function Connect to CD-ROM Drive Rear Panel Connectors and JumpersCD-ROM Drive Rear Panel Connectors and Jumpers CD-ROM R/W Front Panel Introduction CD-ROM R/W Drive CD-ROM R/W Drive Rear Panel Connectors and Jumpers DVD-ROM Front Panel Introduction DVD-ROM Drive Front Panel and Emergency-Exit Function Connect DVD-ROM Drive Rear Panel Connectors and JumpersDVD-ROM Drive Rear Panel Connectors and Jumpers Dimm Configurations Monitor Port Signals System Board Connector Pin SignalsSerial Port Signals Pin Signal Name Keyboard Port Signals Parallel Port SignalsMouse Port Signals Diskette Drive Cable Connector Signals IDE Cable Connector Signals Safety Inspection Guide General Guidelines Parts Catalog Parts Catalog Country Language Version Abbreviations Assembly 1 System Uni System AssemblyAsm Index Number IBM Desktop System HMM Assembly 2 Diskette, Hard Drive and Zip Drive Assembly 3 CD/DVD-ROM Drive Assembly 4 Power Cord Assembly 5 Keyboard and Mouse FRU Number Asm-Index FRU Number List 20L2197 Online Support Appendix B. Online Support InformationPage Index Audio Check ProcedurePage Page