IBM 2274 manual Error Symptoms Action/FRU CD/DVD-ROM Drive

Error Symptoms Action/FRU

CD/DVD-ROM Drive

NOTE: Ensure CD/DVD-ROM drive is configured correctly in Configuration/Setup Utility, cable/jumper are set correctly and its laser beam is clean before diagnosing any CD/DVD-ROM drive problems.

CD/DVD-ROM drive LED	1.	CD/DVD may have dirt or
flashes for more than 30		foreign material on it.
seconds before LED		Check with a known good
shutting off.		disc.
Software asks to reinstall	2.	CD/DVD is not inserted
disc.		properly.
Software displays a reading	3.	CD/DVD is damaged.
CD/DVD error.
CD/DVD-ROM drive LED	1. CD/DVD-ROM drive
doesn't come on but works
normally.
CD/DVD-ROM drive cannot	1.	See “CD-ROM
load or eject when the		Emergency-exit <option
system is turned on and its		1>” on page 120 and
eject button is pressed and		“CD-ROM Emergency-
held.		exit <option 2>” on page
		120.
	2.	Disconnect all cables
		from CD/DVD-ROM drive
		except power cable, then
		press eject button to try
		to unload the disk.
	3.	CD/DVD-ROM drive
		power.
	4.	CD/DVD-ROM drive
CD/DVD-ROM drive does	1.	CD may have dirt or
not read and there are no		foreign material on it.
error codes or messages		Check with a known good
are displayed.		disc.
	2. Ensure that the CD/DVD-
		ROM driver is installed
		properly. See “CD/DVD-
		ROM Drive” on page 63.
	3.	CD/DVD-ROM drive.

Check Procedures 49