Sony SDX-800V manual Creating Disaster Recovery Tape, Exiting DR Mode, Read 10 28h, Read Capacity

14. Appendix G

14. APPENDIX G: DISASTER RECOVER

14.1.Overview

This chapter will outline the Disaster Recovery Firmware Specifications for Sony AIT drive and autoloader. This is applicable only to Windows NT/2000 Operating System. While in Disaster Recovery mode, the drive behaves as a bootable CDROM device. Using the DR tape image, users will be able to do a complete restore of the system.

14.2.Creating Disaster Recovery Tape

The Disaster Recovery tape must have the CDROM image of the operating system written first on the tape. This image is formatted in El Torito CDROM Boot Specification.

Disaster Recovery Tape can be created using Veritas BackupExec Software. Please follow instructions of Veritas BackupExec to create the DR tape. After the tape has been created, the tape must be write-protected to be considered DR tape.

14.3.Configuring The Drive For Disaster Recovery Operation

To enter DR mode, the tape drive needs to be configured with the following steps:

1.Insert a write-protected DR tape and wait for the drive to complete the loading sequence.

2.Observe the simultaneous flashing all LED. This is the DR standby mode. The drive will remain in this mode for a period of 15 seconds. Powering down the drive during this 15 seconds window will trigger the DR mode. The drive will exit the DR standby mode after 15 seconds and resume normal mode of operation. A SCSI reset will force the drive to exit the DR standby mode and service the SCSI reset.

3.Upon power up, the drive will enter the DR mode. Observe the simultaneous flashing LEDs of TAPE MORTION and CLEANING REQUEST. While in DR mode, a SCSI RESET will be treated as soft reset and will not take the drive out of DR mode.

Also, the drive will enter DR mode upon receiving a Mode Select command with Page Code 0x3C.

14.4.Exiting DR Mode

Ejecting the media via the front panel button or a SCSI UNLOAD command will exit the DR mode and restore the drive to normal operation. A SCSI Mode Select command with Page Code 0x3C and DREnable bit of zero will also exit the drive out of DR mode. On the autoloader, the DR mode indication on the 4th line of the LCD will disappear once the drive exits from DR mode.

14.5.Supported CDROM DR Command Set

14.5.1.Inquiry (12h)

5.1.1.Peripheral Device Type = 0x05 (CDROM)

5.1.2.Byte 43 = 0x24 (ASCII “$”)

5.1.3.Byte 44-48 = “DR-10”

14.5.2.Read 10 (28h)

This command shall only be supported in DR mode. Execution of this command is in effect a translation of a LOCATE command and READ 6 (0x08) command executing in sequence.

14.5.3.Read Capacity (0x25)

This command shall only be supported in DR mode.

5.3.1.Returned LBA (Capacity) = 0004B000h (~640 Mbytes)

5.3.2. Block Length = 00000800h (2048 Bytes)

SONY AIT-3Ex drive SDX-800V series Ver.1.1 14-1